In the "Edit Load" section in Abaqus, I saw the "Magnitude" value, so how do I get the value of it with Load: Sigma = 1MPa? Does it have any formula to it?
you can directly set the value of "Magnitude" to 1MPa. There is no specific formula involved in this case as it is a direct assignment of the desired load value.
Long Le, there are two ways to control pressure with amplitude in Abaqus:
- Direct Pressure: Specify the pressure value directly in the load definition. This is suitable if you want a constant pressure throughout the analysis.
- Amplitude Control: Define a separate amplitude curve to control the pressure variation over time. Then, in the load definition, reference this amplitude and specify a pressure value (1 MPa in this case). This pressure value acts as a scaling factor.
Important Note: The amplitude value itself should be between 0 and 1 (inclusive). A value greater than 1 will result in a pressure exceeding 1 MPa because Abaqus calculates the final pressure as: time x amplitude x pressure. If you still are facing issues in your project, feel free to reach me out on https://wa.me/+923440907874 for free guidance. Share your problem with me in screenshots on my WhatsApp and i will try to guide you properly. Good luck!
- Badges
- Science topic
- Similar topics
- Engineering
- Thermal Engineering
- Thermofluid
- Heat Transfer