How to calculate R2 in Multilevel Mediation (2-1-1) using MLMED?

23 April 2022 0 5K Report

Hi colleagues,

I conducted multilevel mediation analysis (2-1-1) by using Rockwood's MLMED software. I was surprised to see that no R2 for M and Y is reported. Is there any way to calculate the R2 by hand given the information provided in the MLMED output?

Any advice is much appreciated.

Best wishes

Sebastian

Badges
Science topic

More Sebastian Wachs's questions See All

How to upload pdf of my articles published?

03 March 2021 2,183 3 View

Paired Samples t-test or repeated measure ANOVA?

Dear Research Gate members, for my masters's thesis, I have conducted a questionnaire to investigate consumer's attitude towards sport sponsorship. I've asked three identical questions...

27 January 2021 2,910 3 View

How to ensure diversity and fight stagnation in a complex two-objective optimization problem?

I am working on solving an optimization problem with two objectives by using neuroevolution. I use NEAT to evolve solutions which need to satisfy objective A and objective B. I tried different...

27 January 2021 4,875 3 View

What is the use of Carbon and Proton NMR Spectrum in Peptide Analysis?

Am in Peptide / Protein Research, may i know what useful analytical information we are getting from 13C & 1H NMR spectroscopy analysis? Somebody getting NMR for smaller proteins, any useful...

05 January 2021 1,196 7 View

Where can I find data on the total atmospheric absorption for a standard atmosphere?

Graphs like the one attached below can be found on every website explaining the spectral properties of the atmosphere. However, I wasn't able to find the data behind these graphs. I need the...

07 December 2020 2,851 4 View

Is there some kind of Octave package (or script) available, to interact with a PEAK CAN USB (or some other CAN hardware) device?

In MATLAB, you can use the Vehicle Network Toolbox, which supports CAN interfaces. I'm searching for something similar in Octave.

06 August 2020 9,571 2 View

In Porphyrin chemistry, what are the allowed limits of deviation (In percentage) from Elemental Analysis and Mass spec?

I synthesized some (metallo) porphyrins. I am now characterizing them by Mass spec and also confirming their purity by Elemental analysis. The values I got are a little deviated from the...

26 July 2020 2,886 2 View

Can you recommend any publications or authors on "The Impact of the IT&C Sector Upon a National Economy"?

Judging by most stock markets, "Big-tech" seems to be the success story, yet there are surprisingly few academic research papers written on this phenomenon. We are looking for studies and authors...

23 July 2020 5,074 3 View

About Fortran and defining the units?

Hi to all. I am doing a large set of calculations employing as input files called 1.log, 2.log, 3.log,......, 300.log. Usually I use this definition for the input file: OPEN(5,FILE='...

12 July 2020 5,027 12 View

Submission of dna sequences to NCBI?

When i submit dna sequences to NCBI, they ask for clarification saying "Some or all of the protein coding sequences contain internal stop codons, reading frame shifts (insertions/deletions...

03 July 2020 6,101 1 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence?

I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance

03 March 2021 3,568 1 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View

How to increase a model accuracy ?

dear community, my model is based feature extraction from non stationary signals using discrete Wavelet Transform and then using statistical features then machine learning classifiers in order to...

03 March 2021 6,994 5 View

Do I need to do linear regression before running mediation analysis using PROCESS MACRO by Hayes ?

I just wanted to check if I need to run a linear regression separately if I am using PROCESS MACRO to run mediation analysis. Thank you.

02 March 2021 4,359 3 View

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

How to calculate average trend in maximum annual NDVI from MODIS?

I am wanting to calculate the average trend in maximum annual NDVI in Iceland from 2010-2020 using MODIS MYD13Q1 V6. How would I do this? I have currently inserted the NDVI bands from the MODIS...

02 March 2021 752 2 View