How to calculate Energy yield in terms of KJ/L/d during bio-hydrogen production. (highlighted in red circle)?

More Santhana Krishnan's questions See All

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

How are Large Models Exploring and Outputting Knowledge Understanding in Specific Content Areas, and What Does Academic Research Say About It?

Hello everyone！ I am currently exploring the performance of large models in understanding knowledge in specific domains, and attempting to construct a knowledge framework similar to what...

05 August 2024 5,729 2 View

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity?

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity? What is the acceptable percentage of error (regardless of the metric)? Could you suggest...

03 August 2024 5,358 0 View

How do i get an account to upload my published papers?

need to open an account to upload my published papers

01 August 2024 9,255 1 View

What is the problem with these tissue culture plants?

All plants are green but some of these plants becomes yellow. I did not found any reason. Please help me to find out the real problem.

01 August 2024 589 4 View

How to correctly use the UTE and ZTE pulse sequences in Bruker's ParaVision software?

I am using a Bruker 600M solid-state NMR spectrometer with a Micro 2.5 microimaging system. The test sample is a tube of 1M LiCl aqueous solution, and the nucleus detected is 1H. I am trying to...

01 August 2024 9,227 1 View

Is artifacts in XPS possible to build high deviation in binding energy larger than 5 eV??

Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...

30 July 2024 9,824 2 View

Which statistical test should we use?

N=6 Comparing pre and post test likert scale responses. Participants are mix of practicing & preservice teachers.

30 July 2024 7,233 4 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

Can the limit of quantification (LOQ) of an analytical method fall outside its linear dynamic range, or must it always be within it?

Can an analytical method's limit of quantification (LOQ) be outside its linear dynamic range, or is it always required to be within it? Please provide a thorough explanation supported by verified...

29 July 2024 7,198 9 View

How to develop investments in renewable energy sources?

08 August 2024 5,112 3 View

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

Why results of ROS flurescence are negative as there was no bacteria within?

Hello. I am working on ROS production of two systems: system A is cerium oxide and hydrogen peroxide, system B is cerium oxide nanoparticle, hydrogen peroxide and potassium bromide. I did some...

04 August 2024 5,974 3 View

How to Transform my handy-wavy explanation of why group I/II metals oxides in aqueous solution are basic into a rigorous argument?

I heard an explanation about something being a better proton acceptor or lone pair donor but that doesn't make sense. I couldn't explain in in terms of acid-base theory. The hand-waving way I saw...

03 August 2024 9,918 0 View

What is the ionic radius of Hydrogen anion? And how to know the exact ionic radii of the elements?

I'm trying to calculate the tolerance factors of the hydride perovskite and the value calculated by me and the reported values are contradictory. Need more clarity in using the correct ionic radii...

01 August 2024 2,614 1 View

Is it possible to improve the reforming section of the Haber-Bosch process without using air separation units?

A typical reforming section in a large-scale Haber-Bosch process (Figure 1) comprises two reactors. A mixture of methane (CH4) and steam (H2O) is fed into a primary reformer to produce syngas via...

01 August 2024 7,051 5 View

Recovery rate after peptide desalting using Sep-pack C18 1 cc Vac Cartridge?

Recently I'm trying to use Sep-pack C18 1 cc Vac Cartridge (Waters: SKU: WAT054955) to desalt digested peptides. However, the recovery rate is usually 40-60%. What is the normal recovery rate?

31 July 2024 6,544 11 View

Is artifacts in XPS possible to build high deviation in binding energy larger than 5 eV??

Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...

30 July 2024 9,824 2 View

How to make the concentration measurements for the hydrogen absorption/desorption in the metal hydride?

Hello Everyone! I am trying to create a metal hydride system where I am trying to create a temperature control with the emphasis on measuring the concentration of the hydrogen with the hydrogen...

29 July 2024 7,577 2 View

Is there a database with onshore wind production for the wind farms in Portugal?

I am looking to predict some production for future onshore wind energy production in Portugal, is there any database with info of performances of the existing wind farms in the country? something...

28 July 2024 1,750 1 View

Mohsen Darabi

What exactly do you mean?

Mehdi Aliehyaei

Dear madam

kiloJoule per liter per day means in one day how much hydrogen is produced and in each liter howmuch energy is stored.

Regards

M.A.Ehyaei

Razieh Rafieenia

Dear Santhana

You may have a look to our recently published paper:

Effect of inoculum pre-treatment on mesophilic hydrogen and methane production from food waste using two-stage anaerobic digestion

Absorption coefficient of methane?

How are Large Models Exploring and Outputting Knowledge Understanding in Specific Content Areas, and What Does Academic Research Say About It?

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity?

How do i get an account to upload my published papers?

What is the problem with these tissue culture plants?

How to correctly use the UTE and ZTE pulse sequences in Bruker's ParaVision software?

Is artifacts in XPS possible to build high deviation in binding energy larger than 5 eV??

Which statistical test should we use?

How to build my own lab made four point probe set up?

Can the limit of quantification (LOQ) of an analytical method fall outside its linear dynamic range, or must it always be within it?

How to develop investments in renewable energy sources?

Absorption coefficient of methane?

Why results of ROS flurescence are negative as there was no bacteria within?

How to Transform my handy-wavy explanation of why group I/II metals oxides in aqueous solution are basic into a rigorous argument​?

What is the ionic radius of Hydrogen anion? And how to know the exact ionic radii of the elements?

Is it possible to improve the reforming section of the Haber-Bosch process without using air separation units?

Recovery rate after peptide desalting using Sep-pack C18 1 cc Vac Cartridge?

Is artifacts in XPS possible to build high deviation in binding energy larger than 5 eV??

How to make the concentration measurements for the hydrogen absorption/desorption in the metal hydride?

Is there a database with onshore wind production for the wind farms in Portugal?

How to Transform my handy-wavy explanation of why group I/II metals oxides in aqueous solution are basic into a rigorous argument?