How to calculate channel capacity loss and MEG for MIMO antenna from S-parameters using HFSS?

Samira Mekki @Samira-Mekki

04 March 2022 1 4K Report

Hello,

please I would like to know how to plot MEG (in dB) and Channel Capacity Loss (in bits/sec/Hz) in Ansys HFSS.

It would be very kind if anyone could guide me in viewing these results.

Thanks in advance.

Foez Ahmed

Dear Samira,

Please read the follwoing papers to get the idea of how to compute and plot MEG and CCL from S-parameters/FF. I am wondering if any way to compute and plot MEG/CCL directily in HFSS!

https://iranjournals.nlai.ir/handle/123456789/337243

https://ieeexplore.ieee.org/abstract/document/6711883/

Best regards

Foez

Badges
Science topic

More Samira Mekki's questions See All

My question is about errors in Ansys mechanical APDL? Data file file.db does not exist for RESUME?

I did a welding simulation using ANSYS MECHANICAL APDL. The solution was done, but I encountered this error in the output file (Data file file.db does not exist for RESUME). On the other hand, I...

11 July 2024 4,480 0 View

What Remote Sensing Software Is User-Friendly for Urban Ecology Research?

Hello everyone, Our lab is currently looking to purchase user-friendly remote sensing software, particularly for individuals without a background in remote sensing or coding. Ideally, we are...

05 June 2024 2,940 6 View

By which acid can we replace sulfamic acid to eliminate nitrite in a soil extract to determine the nitrate content by the DEVARDA method?

by which acid can we replace sulfamic acid to eliminate nitrite in a soil extract to determine the nitrate content by the DEVARDA method

26 May 2024 5,822 1 View

Could you provide me with the ISO protocol for measuring nitrites and nitrates in soil?

Could you provide me with the ISO protocol for measuring nitrites and nitrates in soil?"

25 May 2024 252 0 View

Nitrate dosage KCl?

Can I apply the nitrate dosage method in water to the soil extract with KCl?

25 May 2024 8,169 4 View

About subtypes of Dyslexia : Single article containing: "Double Deficit Dyslexia," "Surface Dyslexia", "Rapid Naming Deficit"...?

I am unable to find a source containing all subtypes of dyslexia ("Double Deficit Dyslexia," "Surface Dyslexia", "Rapid Naming Deficit"...) in a single article to use as a reference for my...

27 March 2024 8,454 2 View

How we can add PIN Diode in CST ??

Hello All i want to design a reconfigurable antenna for which i have to use PIN diode as a switch. anyone help me how to add PIN diode in CST i mean in schematic ?? Thank you

04 March 2024 8,098 1 View

I have a new article and I want to publish it in your journal , how can I do this?

I have a new article and I want to publish it in your journal , how can I do this? I have defended my dissertation recently and taken a short article from it

14 February 2024 673 3 View

CO and Cross polarization using HFSS or cst?

Greetings, Please how can i plot Cross or CO polarization on both hfss and cst Thank you

15 October 2023 4,393 2 View

Immunofluorescent marker for SH-SY5Y cells?

Hi everyone. we are doing IF for checking the translocation of a protein between cytoplasm and nucleus in SY5 cells , and I need a marker better than NeuN to visualize the whole cell and make it...

07 August 2023 9,942 4 View

How can I prepare virus for a TEM or SEM imaging?

I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?

11 August 2024 3,115 1 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

How are iso-frequency contours plotted?

Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...

07 August 2024 1,937 1 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

RNA later for the preservation of RNA in fecal samples at room temperature for one day (37°C)?

I am planning to collect human fecal samples for metatranscriptomic analysis using MGI. These samples are from indigenous people living in a region with high temperatures. I will have access to a...

06 August 2024 1,367 3 View

Please explain how the plastic input value should be considered from the true stress-strain curve for the bilinear elastoplastic material model ?

I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...

05 August 2024 454 3 View

Is it necessary to covary exogenous constructs in a structural model?

I am working on a SEM model where i have 7 latent variables (6 exogenous and 1 endogenous). In AMOS when I co-vary the exogenous constructs, only 2 paths are coming significant out of 6. But when...

03 August 2024 6,028 4 View

What do you consider to be the most relevant elements of EEG for studying cognitive biases?

I've seen articles that primarily focus on alpha and beta activity in the frontal regions, but these studies often compare healthy subjects with those having various pathologies. I haven't seen a...

31 July 2024 7,259 1 View

In SEM, if a latent variable consists of three observed variables, and each observed variable has four items, what should I do?

Suppose I am studying the construct of "Academic Motivation" (latent variable) in students, which is measured through three observed variables: "Intrinsic Motivation," "Extrinsic Motivation," and...

31 July 2024 3,913 6 View

How to improve peaks separation in HPLC?

Hi everyone, I'd like to better separate two close peaks coming from a bioconversion sample, I'm currently using a C18 KromaPhase 4,6mm Ø.I. SCHARLAU, particle size (µm): 10, pore size (Å): 100,...

30 July 2024 435 3 View