How to avoid drop coming after subcutaneous injection in mice?

More Prajakta Biyani's questions See All

Which approach is better to avoid pressure surges occuring in case of extreme valve position changes?

The existing control system for the fluid flow control consists of a cascaded PI controller with inner (faster) PI controller for controlling valve position change and outer (slower) PI controller...

12 January 2016 4,682 3 View

Waters 2707 HPLC autosampler problem?

I am using a 2707 waters HPLC device. When I try to inject a sample, it says missing plate or rack. I changed the needle and calibrated its position but I still get the same problem. I even get...

02 March 2021 1,408 1 View

How does the injection volume impact LLOQ and ULOQ in regression analysis (LC-MSMS)?

Hello, I have run into an issue that has sparkled a debate at work: is the LLOQ/ULOQ impacted by injection volume under the following circumstances: 1) Same dilution factor of all samples 2)...

23 February 2021 9,159 3 View

How can we add reinforced thermoplastics with granules in injection molding machine?

I need to make an injection molding machine in which short fibers are to be introduced. Short fiber length and material properties are to be determined and also the material strength are to be...

22 February 2021 4,290 1 View

Will rat colon cancer cells (DHD/K12) derived from BDIX rats grow in Sprague Dawley ?

we plan to induce colon cancer by injection. Cell lines derive from BDIX rats, but our experimental setting would favour SD rats. any experience?

23 January 2021 1,437 2 View

2.6 Drying gas flow controller cannot regulate the requested setting after a fixed amount of time?

We keep getting this error on our Agilent 6470 TQ. We were told it could either be our N2 generator or filter traps. We've called the manufacturer of our generator and they believe it's working...

21 January 2021 2,969 1 View

Is there a study on the maximum thumb extension that can be possible in a range of population while using injectors?

In Most pen injectors while dialing the dose, the dose dialer comes our or extends outside the pen as dialing happens. How much maximum extension of dialer is acceptable for performing...

17 January 2021 9,770 1 View

How to couple Moldex 3D with MATLAB for design optimization of an injection mould?

Hello, I would like to use the software Moldex 3D for the design optimization of an injection mould. How can I couple Moldex 3D with a MATLAB code? Any help appreciated, I wish you all a happy...

09 January 2021 569 2 View

How to setup ANSYS Fluent for simulating the filling stage of an injection mould?

Hello, I am using ANSYS Fluent for simulating the filling stage of an injection mould. However, when comparing the results with those of specialized software, such as Moldex 3D, I found the...

07 January 2021 7,992 1 View

Do drugs that are injected i.t in rats reach the supraspinal system and how long does it take to clear them from spinal cord?

I am injecting intrathecally (between L5-L6) , in rats, cannabinoid analgesics and I was wondering if they can reach the brain and have effects there as well ? Also I need to pretreat with...

07 January 2021 5,397 4 View

How big the Balb/c mice spleen after immunization?

I am working with Balb/c mice, and in my experiment, I have to inject mice with antigens, then get their spleen and collect the splenocytes for fusion. Recently, I get into trouble with the mouse...

04 January 2021 3,591 3 View