I am trying to add bioglass nps in SA/CH blend solution using following weight % ratio:

1. SA/CH/BG: 60/40/1% : SA/CH blend solution is 100ml and 1gm Bioglass

Problem I am facing: I have to print that composite solution into 3D scaffold that require a minimum printability of that solution. To accomplish this, I mixed bioglass (1gm) in SA/CH blend solution and kept for 12 hour for complete mixing (digital image attached with this file). After mixing the solution I found that a white precipitate , which was not as per my requirement.

How can I mix the bioglass in the solution so that I can print that composite slurry or solution in form of 3D scaffold.

More Amit Singh's questions See All
Similar questions and discussions