Can someone please give me the video procedure about how to apply reinforcements?
I am trying to generate flat plate and column connection. I don't know how to apply steel bars into concrete. I searched on the internet but I didn't get any videos about it.
I think , you'll find your answer in the following link:
you can simulate full bond interaction between concrete and reinforcement and insert the reinforcement as wire or bar and put the material properties for steel and concrete separately.
You may get in this, ABAQUS, (2004), Example problems manual. .check it once...
thanks @navid..
@majid sir.. should I give wire in part?? i have given solid. and my main doubt is..how to assemble reinforcements into concrete in assembly part?? because the structure I am going for is a flat plate. and there are so many reinforcements in it. so according to coordinate if i assemble, it is too lengthy and difficult.
@manpreet singh.. do you know about fibres too?? the second model i have to make with hooked end steel fibres... if you can help me.. what shuld i take to start part.. should i take wire for fibre part and then provide it as truss or shell element?? and which type of element in mesh ??
actually i want to know the steps.. how to begin with ?? like you told me to take wire and then providing it as a truss element in reinforcement case.. what should i do and select for fibres??
Just input the stress strain behaviour of fibre reinforced concrete and that will be sufficient to consider the fibre effect
I am sorry but I am new to abaqus and I am not getting how to do this!!! :( how to give the stress strain behaviour of frc in abaqus..
There are different approaches. Smeared reinforcement is way to model the rebar. The documentation has the details on this regard.
have you make out this modle?i need an example too.l am new and try to work out a modle but fail to convergence.hope you can help!thx!
Hi, You can use Truss Element to define reinforcement and after that use the Embedded option to define the Interaction.
I used truss elements and embedded them in concrete. But I couldnt get the rebar results, and got this warning "Rebar output is available only in membrane, shell, or surface elements at the integration points and at the centroid of the element." I have already click to the "output for rebar" option, nothing solved.
so does it means that we can not get results for rebars in solid elements ?
You can model 3D concrete solid elements building in Abaqus,by using skin & stringer to model reinforcement, by this way you can show all stress & cracks in 3D elements better than line elements
please could i get a link,which will help me to model flat slab and drop panel ?
- Badges
- Science topic