Hi Azadeh,

Using node to node Tie constraints between corresponding nodes, you should be able to do connect beam element to solid element. 

regards,

Anshul

hi dear Azadeh Amiri

you can use tie constraint  for connect to shape. 

i think this error refer to Node to surface or surface to surface ,.change it.

Regards

Alireza

Dear Anshul Faye,

I'm using node to node Tie constraints between corresponding nodes, but this error appears : For *tie pair (assembly_s_surf-15-assembly_m_set-142_cns_), adjusted nodes with very small adjustments were not printed

Do you have any idea?

Regards,

Azadeh

Dear Alireza,

I examine Node to surface or surface to surface,.. but the error still exist!!!

"For *tie pair (assembly_s_surf-15-assembly_m_set-142_cns_), adjusted nodes with very small adjustments were not printed"

I'm really confused.I don't know what is the problem?!

If you get anything, please share it to me.

Sincerely,

Azadeh

Dear Azadeh,

Without looking at the model it will be difficult to say exactly where is the error.

regards,

anshul

Hi Azadeh Amiri, 

Have you tried merging two part instances? Please note that when you merge two part instances, it will create a new part and with the same section assigned. You need to reassign the sections (solid and beam) to the newly created part. 

Based on your description of the problem, i have created a simple example. Please have a look at the model and let me know if your requirement is something else. 

Regards,

Ranjith. 

Hello Ranjith,

Thanks alot for your suggestion.

I'll try to do this.

Regards,

Azadeh

Hi Azadeh Amiri,

I don't know do that in Abaqus, but in my Master Thesis using software Code-Aster, it can connect 3D Beams to 1D elements. It may be help you

http://www.code-aster.org/doc/v12/en/man_r/r3/r3.03.03.pdf

Regards,

Anh-Tuan