Dear sir, how create model and meshing of pipe in ICMCFD.
Can any body list the concepts of physics and chemistry, which must be required for a mechanical engineering student.
10 November 2018 481 0 View
What is the procedure to write vision, Mission, Cos and POs for curriculum Development.
09 October 2018 2,997 1 View
What are the knowledge areas of Mechanical Engineering. Is there any suggestions by ASME or other professional bodies.
08 September 2018 2,539 0 View
what are the potential areas in heat transfer to do research work in heat transfer?
02 March 2017 875 4 View
09 October 2016 6,340 2 View
06 July 2016 5,977 4 View
Can any body explain the procedure to design spiral heat exchanger and what is the cost involved. Approximate cost also.
05 June 2016 8,577 1 View
in space applications. especially in the domain of rocket launching and its preparations.
05 June 2016 6,130 0 View
01 February 2016 9,269 2 View
31 December 2015 1,691 19 View
I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...
03 March 2021 1,931 5 View
Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...
02 March 2021 4,569 4 View
Hello! I have a dataset of n=3000 nested within 8 countries with approximately 200 or 400 responses in each country. I originally planned to perform multilevel modelling with 4 dependent variables...
02 March 2021 6,865 1 View
I am interested in evaluating mesh optimization solvers that converge to high aspect ratio unstructured hexahedral grids. In other words, I am interested in a solver that optimizes warpage,...
26 February 2021 7,279 2 View
In R-studio, there are many commands of Gumbel package. Arguments are also different. I`m asking about the alpha parameter of the Copula which must be greater than 1. If this is the one used to...
25 February 2021 5,229 3 View
I have a pipe with 10 mm in Diameter and 2 bar pressure, the fluid velocity is 200 m/s, the fluid is air. is there a way to reduce velocity without affecting the pressure value?
25 February 2021 7,187 3 View
Hello, I have used the shell function on SpaceClaim to create thin solids for the model I am studying. These are contained within an enclosure for my study. I chose this approach as it avoids the...
24 February 2021 8,856 3 View
I want to map these river geoforms with as little subjectivity as possible. I have a high resolution DEM generated by drone data.
22 February 2021 7,800 3 View
Hello everyone, hope all is good. I want to analyse multi-phase fluid flow through pipe, which software is best to do so ?
21 February 2021 4,230 8 View
I am planning to work on T2 diabetic animals and check the efficacy of probiotics. My initial plan is to fed B6 animals with HFD for a while. But now, I have the chance to work on ob/ob mice. My...
18 February 2021 6,896 3 View