Dear RG,
How can you justify variation in the cavitation yield of biodiesel adopting various alcohol, catalyst and reactors?
Maybe you should read about it or the answer might be a bit long.....
Start with these:
https://books.google.no/books?id=4oZwAgAAQBAJ&printsec=frontcover&dq=the+science+of+biodiesel+production&hl=no&sa=X&ved=0ahUKEwjhtO2Nl6TgAhVQiKYKHQIyBH8Q6AEIKDAA#v=onepage&q=the%20science%20of%20biodiesel%20production&f=false
Article Biodiesel Production: A Review
Cheers!
Thank you for your wonderful Mário Silva..
Best Regards,
You may find answer to your question in this article Article Ultrasound assisted intensification of biodiesel production ...
Due to the unavailability of climate rooms, I want to carry out an experiment that require the use of certain saturated salt solutions especially those that can condition the wood specimen to 35%,...
25 February 2021 8,139 1 View
I'm currently working having problem with the concentration for recombinant protein use in western blot, the one been used is Recombinant Human CD19 Fc Chimera Protein-rndsystem which does not...
24 February 2021 8,514 3 View
I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....
24 February 2021 4,428 3 View
I was wondering if anyone knew how to perform the Haldane correction for SPSS (this is the definition of the correction -...
21 February 2021 2,882 1 View
I am calculating emissions considering the uncertainty of the data to do Monte Carlo simulation. Some variables such as yields have normal, lognormal or even uniform distributions. These must be...
03 February 2021 6,318 5 View
I urgently need a map that shows the point locations of informal settlements in South Africa. I am currently working on a study that seeks to relate protests location to the location of informal...
02 February 2021 4,113 7 View
I am in the process of conducting a meta-analysis assessing effect of adjunct radiotherapy on overall survival. Some of the final studies included for analysis use the same national databases for...
02 February 2021 9,211 2 View
26 January 2021 7,830 4 View
Hello, Please, I need your opinion. I want to map the depth of 20,000 hectares of land. I have sampling points of 20,000 with their respective depth attributes and photos of the topsoil(less than...
31 December 2020 4,325 3 View
I am working on aerosol retrieval using a radiative transfer equation with Landsat 8 OLI, and I am having difficulty determining the raster-based path radiance. I am using the formula by Felix C....
11 December 2020 6,662 2 View
I want to polymerize TEOS on a surface. I know that NH4OH is a preferred catalyst and an alcoholic solvent should be used .But I can not find certain amounts of each material to use. Does any one...
02 March 2021 1,404 6 View
Dear All, I want to quantify carbon deposition on the surface of the CuZnAl catalyst. I have tried thermogravimetric analysis, but I've got weight gain as the active Cu- get oxidised. Does anyone...
01 March 2021 1,907 3 View
I am doing my thesis on the nutrient deprivation on the macroalgae Rhizoclonium sp. I will be analysing the levels over a period of roughly 5 days by HPLC-UV and GC/MS. I will be using seawater as...
28 February 2021 6,477 1 View
there are solvents and alcohol in the waste water of a factory that produces disinfectants. Increasing this waste water requires very serious operations. Can I treat this waste water with...
27 February 2021 2,609 3 View
Biodiesels derived from waste vegetable oil transesterification with Ethanol (FAEE) show higher peroxide values than those derived by transesterification with methanol (FAME) prepared under the...
13 February 2021 193 6 View
Hello everybody, I would like to simulate a three phase reactor and study its hydrodynamics. I would like to know which type of software is better? I have a good command of ANSYS Fluent and I am...
10 February 2021 4,303 3 View
I am trying to prepare a Polyvinyl alcohol membrane for carbondioxide adsorption
08 February 2021 7,493 3 View
Dear all: Currently I am working with polymerization reaction in a reactor. For this, I need to control temperature, pressure, agitation speed etc. For calculation of rate of polymerization, I...
07 February 2021 355 2 View
The usual way of properly removing and collecting carbon nanotubes (CNT) is to sonicate the stainless steel plates coated with CNT under isopropyl alcohol (IPA) solution, remove the plates after...
28 January 2021 9,455 1 View
I am designing a metal oxide catalyst and among many characterization of this sample, TPR emerges quite significantly. The brief explanation in journal is limited to the sample that is...
21 January 2021 6,346 1 View