How can we determine the SiC face (carbon and Si face) using Raman on epitaxial Graphene?

Muhammad Farooq Saleem @Muhammad_Farooq_Saleem

04 April 2018 0 8K Report

I have epitaxial Graphene samples. I have the Raman spectra of the two faces of the sample. I’m wandering how to determi the SiC crystal face and phase using Raman spectroscopy.

Badges
Science topic

More Muhammad Farooq Saleem's questions See All

How to reduce lattice mismatch and dislocation densities in epitaxial films?

what factors affect an epitaxial film's lattice matching and dislocation densities? Are there any possible ways to reduce lattice mismatch and dislocations in various deposition techniques?

10 November 2019 9,343 3 View

What is the difference between fluorescence and luminescence background in Raman spectra?

what is the difference between fluorescence and luminescence background in Raman spectra? What kind of materials give fluorescence background and what kind of materials give luminescence background?

06 July 2019 1,905 2 View

What will the mixture of a direct and indirect band gap semiconductor be?

Cu2O and CuO are direct and indirect band gap materials respectively. We deposited a film that shows the Raman signatures of both CuO and Cu2O, what will be their band gap, direct or indirect?

05 June 2019 3,222 3 View

What are the easiest methods of doping graphene?

I have CVD graphene transferred to substrates. I am interested in p and n-doping of graphene. Are there any simple, easy and controllable methods of doping graphene films?

04 May 2019 1,269 9 View

How sometimes Raman-inactive and IR-active modes are observed in Raman spectra?

Sometimes, we can observe the IR-active and Raman-inactive modes in Raman spectra. What are the reasons behind the Raman activity of such modes?

04 May 2019 7,364 5 View

What can be the possible reasons and solutions of sample's surface going out of focus during in situ temperature dependent Raman spectroscopy?

We tried two different temperature dependent Raman set ups for our study. Every time we do temperature dependent Raman spectroscopy for a sample, the Raman signal is lost or quenched at some...

04 May 2019 3,759 8 View

What materials are highly sensitive to temperature?

what are the most temperature sensitive materials? Are there any materials that respond quickly to the abrupt temperature variations? I am interested in thin films mainly. I want find some...

03 April 2019 8,529 3 View

How to explain the IV data of photodetectors attached?

Its a photodetector.

03 April 2019 9,693 5 View

Which laser source is generally use for Photodetector IV measurements, pulsed laser or continuous laser source?

We have a pulsed laser source, and I have fabricated graphene based photodetectors, I want to study the IV characteristics and photoresponse of the devices. We don;t have a power meter, we have a...

03 April 2019 2,886 5 View

What are the in situ temperature dependent surface analysis techniques availabe?

I want to observe the surface of a sample in situ at different temperatures. Is it possible to take surface images at a particular temperature (mainly cryogenic temperatures)? If not, what in situ...

03 April 2019 5,173 11 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

How to quantify carbon deposition on CuZnAl catalyst?

Dear All, I want to quantify carbon deposition on the surface of the CuZnAl catalyst. I have tried thermogravimetric analysis, but I've got weight gain as the active Cu- get oxidised. Does anyone...

01 March 2021 1,907 3 View

Why Trivalent chromium start precipitating above PH 5 ? Moreover discuss difference between adsorption of chromium and precipitation of chromium ?

I am a student of MS Environmental Engineering and started my research phase. I am working on metal removal ( chromium iii ) by using activated carbon prepared from the agricultural feedstock. So...

01 March 2021 5,475 2 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

How to remove the residual PDMS on the silicon mold?

Incompletely cross-linked pdms are difficult to remove.

01 March 2021 798 3 View

Why initial concentration of Pb not the same as calculated one when testing using AAS?

I am currently doing research on the adsorption of heavy metal using magnetic reduce graphene oxide. I use AAS to determine the concentration of the heavy metal. I prepare the Pb solution with...

26 February 2021 9,580 4 View

How can I assign a velocity along one direction to CO2 molecules in a molecular dynamics simulation using GROMACS?

Dear all, I am trying to perform a MD simulation about the interaction between CO2 and a polymer. I create my model, solvate it and perform the NVT and NPT equilibration. Now I am not able to...

26 February 2021 10,014 3 View

CGA 300 Regulator for CO2 cylinder?

Has anyone ever tried to deliver CO2 with a CGA 300 regulator? I know that a CGA 320 regulator is standard for CO2. The issue is that I currently do not have any free CGA 320 regulators. I also...

25 February 2021 3,292 3 View

What are the methods used for CNT..?

Respected Professor's i hope you are doing well and happy. i need some information about carbon Nanotubes. before blending the CNT with the matrix the CNT has been introducing in some treatments....

24 February 2021 5,383 5 View

Is this the write procedure for acid digestion of soil for heavy metal analysis using AAS?

How to do acid digestion of soil sample with 3:1 aquaregia in an open vessel?

23 February 2021 3,053 7 View