physics
physics, material science, chemistry
06 July 2016 9,620 0 View
How to remove parasitic effects (capacitance, inductance) due to cable of the temp dependent transport and extract sample resistance with frequency?
05 June 2016 4,448 3 View
02 March 2016 9,176 1 View
Physics, Material Science, Chemistry etc. How can I fit spectroscopic ellipsometric data for pedot:pss thin films on PDMS micron thick film to get the thickness of PEDOT:PSS?
09 October 2015 8,044 3 View
Physics, chemistry, material science,polymer science. How do I model Xray reflectivity data of PDMS to obtain surface roughness and scattering length density in matlab?
09 October 2015 8,750 3 View
physics,chemistry,polymer science,material science, material engineering
09 October 2015 192 3 View
Physics,Chemistry, material science, Polymer science
06 July 2015 7,839 0 View
physics, material science, soft matter
05 June 2015 972 0 View
physics,material science
03 April 2015 7,244 2 View
01 February 2015 2,167 3 View
How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...
10 August 2024 942 3 View
I did PR spin coating on trench structure. I used AZ P4620 PR and the thickness or PR is around 11um. The substrate is Si. And my trench structure depth is 141um(negative way). Even though I...
08 August 2024 2,298 0 View
I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.
07 August 2024 4,526 4 View
I am currently using CASTEP version 2020. When I want to run optical properties calculations with spin-orbit coupling(SOC), I encounter the following error in a pop-up window before the job gets...
02 August 2024 2,890 0 View
I am trying to coat my micelles and PLGA based nanoparticles with cell membrane using an Avanti mini extruder according to literature . I use 200nm membrane but my particles end up to be 400nm And...
30 July 2024 3,294 3 View
In the context of Electron Spin Resonance (ESR) spectroscopy, under what conditions is an absorption spectrum considered to be a single absorption spectrum?
25 July 2024 2,325 1 View
I am trying to coating metal oxide into steel substrate, for better sticking planning to utilse epoxy based, Could you please suggest suitable curing agent for the coating purpose
25 July 2024 438 3 View
I have been harvesting monocyte-derived macrophages from buffalo and cattle fresh whole blood using the same protocol for years and getting good macrophage cultures. Below is the protocol that I...
23 July 2024 4,074 2 View
We are trying to coat some cathode materials on Al-foil ( ex - LiFePO4 , S@CNT, etc). When we coated the Al foil with the cathode (ex - S@CNT) material , the cycling result was annoying. But the...
09 July 2024 5,123 4 View
I tried to make slurry for NCM cathode but there was problem in coating process. The detail of my experiment is following; The ratio between active material(NCM811), conductive additives(Super-P)...
08 July 2024 7,327 4 View
