I Keep getting this error "The volume of 37485 elements is zero, small, or negative. Check coordinates or node numbering, or modify the mesh seed. In the case of a tetrahedron this error may indicate that all nodes are located very nearly in a plane. The elements have been identified in element set ErrElemVolSmallNegZero.".. It occur after I enter the Constraint-tie for my rebar to the ribbed slab. Warning appear as "For *tie pair (assembly_s_surf-7-assembly_m_surf-7), not all the nodes that have been adjusted were printed. Specify *preprint,model=yes for complete printout.".. Where shall i rectify??

Similar questions and discussions