When I trying to start simulation, it encounters an error and stop running and showing this message:
" Unable to open input file *t.unf"
How can I solve this problem??
hi
i can?
i have the same problem
did u find it ?
Dear Ehsan
Yes. this problem occurs because of that you did not selected all elements of enclosure in your boundary condition
thanks a lot
Can any one explain me the reason for "air entrapment" under steel chill in magnesium sand casting?
04 May 2017 4,781 1 View
When I trying to start simulation, it encounters an error and stop running and showing this message: " Unable to open input file *t.unf" How can I solve this problem??
06 July 2016 2,367 1 View
A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...
11 August 2024 9,801 2 View
Hello experts, Does anyone know any free software about retention index prediction ?
08 August 2024 7,403 2 View
A website software of Blackbody radiation law expert software can used through the following web site. http://39.105.188.151:3000/index
07 August 2024 1,706 0 View
Dear QE-users, In the method where full MS positive mode and PRM mode are used, we always get an incorrect auxiliary gas reading (41 instead of 25). This only happens in this method; other...
06 August 2024 4,953 0 View
Hello guys! Do you have experience running a Oaxaca-Blinder decomposition on R applying person weights. How do you suggest doing it? I have a variable PERWT which gives more information on how...
04 August 2024 6,033 0 View
Molecular docking software/ websites?
02 August 2024 8,704 7 View
I'm researching light sources and their UV emissions. I'm curious if a 50W, 7500K conventional LED lamp emits any UV light. I found that a 200W tungsten lamp can emit up to 1.5 mW/cm² at 350 nm....
31 July 2024 3,843 7 View
Hello Everyone I have a question about structure for connectivity analysis on sources. My goal: preprocess and cut data into trials create headmodels, using template MRI file perform source...
30 July 2024 2,744 1 View
When I run autogrid4 it says: autogrid4: ERROR: Unknown receptor type: "Cr" -- Add parameters for it to the parameter library first! Look forward to your reply.Thank you so much!
29 July 2024 488 0 View
I am trying to run a restart analysis, which imports deformed configurations of parts from a generated ODB file. It runs fine in Windows OS but when I try to run it in Linux OS, it is giving some...
29 July 2024 9,572 3 View