Simulation of impacts between ice and steel structures.
Thank you for your answer.
I have tried to simulate the collision between Ice and steel structures to investigate the response of structures after impacting to Ice floes. Could you suggest me about it?
Many thanks
Hi, I have tried to perform an plate subjected to impact load in ABAQUS, after impacting the plate have a permanent deflection, while the plate was still oscillating. So how can I reduce the...
09 October 2015 9,342 5 View
I performed the model consisting of two plate loaded by a mass drops, the tie constraints were used to connect two plates (using shell elements) instead of bolt connection. After finishing the...
06 July 2015 4,514 2 View
ERROR: "The elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively."
05 June 2015 8,172 5 View
It is mentioned by Jones (in the paper "The credibility of predictions for structural designs subjected to large dynamic loadings causing inelastic behaviour") the coefficients in Cowper-Symonds...
06 July 2014 9,095 6 View
I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?
11 August 2024 3,115 1 View
I would like to learn more about SPSS and Its application especially in regards to data analysis. Please suggest me how I can learn more about it. Thank you so much.
11 August 2024 9,101 4 View
I have reverse sequences (AB1 format), can I base on reverse DNA sequences to perform nucleotide alignment, convert nucleotides to amino acids and deposit the sequence in GenBank database?
11 August 2024 5,138 1 View
Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!
11 August 2024 3,770 4 View
Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...
10 August 2024 7,180 0 View
I'm currently exploring the application of Python in textile engineering, specifically in areas like data analysis, process automation, and the development of smart textiles. I'm interested in...
10 August 2024 7,429 2 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
I have input a moment load in module load Abaqus, i put my moment load on the node surface (using reference point). I have define moment in history output and make a set for moment too. But the...
08 August 2024 4,831 4 View
Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...
07 August 2024 1,937 1 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View