Hallo all,

I am writing a script in ANSYS workbench to perform Random Vibration analysis. The PSD response is entererd in the APDL command file. It is not entered in the GUI because I calculate the Exitation based on the input PSD signal multiplied by a Transfer function of a Transfer Box. The goal of this work is to optimize the Transfer Box properties. Therefore, Parametric study is performed and all the input and the outputs are defined in the APDL command line.

So the question is: How can I print the PSD signal before and after multiplying it by the Transfer function ? Is there any APDL command to be used to print that figure?

Thanks in advance

Mohamed

More Mohamed Sayed's questions See All
Similar questions and discussions