How much the nanoparticles reach the inflammatory tissue?

Dear colleagues, I want to know the average analysis data of EPR effect on inflammatory tissue (acute lung inflammation/injury, ischemia/reperfusion, rheumatoid arthritis, and sepsis..) In...

22 December 2020 3,147 2 View

How to measure the bonding strength of transfered graphene on PDMS substrate?

Chemical vapor deposition (CVD) was used to grow graphene on copper (Cu ) substrate, then the single layer graphene was transfered onto a PDMS substrate. I want to measure the bonding strength of...

17 October 2020 3,567 3 View

How to define the particle agglomeration in composite materials or foundry alloys and measure its size distribution quantitatively?

28 June 2020 7,614 3 View

What form of Mg will be selected during the purification of prokaryotic expression protein?

Hello everyone Recently I wanted to purify several proteins by prokaryotic expression, I read some related literature and found that Mg is needed in the protein purification buffer. I am a little...

02 May 2020 931 3 View

Free acid and its salt, can HPLC-PDA-MS tell its difference?

I have a free acid R-COOH and its salt R-COOM. Both are insoluble in water but soluble in methanol. When their methanol solutions are injected into a HPLC-PDA-MS system, are they going to have the...

06 March 2020 4,952 4 View

Sodium chloride solution saturated vapor pressure at sub zero temperature?

Can anyone suggest where to find the data or any equations related to the salt solution vapor pressure at sub-zero temperature? Many thanks!

24 December 2019 7,741 2 View

Does metal always be in reduced state when ligand-to-metal charge transfer can happen?

Does metal always be in reduced state when ligand-to-metal charge transfer can happen? I saw that when the charge transfer complex absorb the light, the electron in ligand can be excited to metal...

16 December 2019 936 3 View

How long do you grind functionalized graphene oxide using mortar and pestle to make it powder form?

I did an experiment of making functionalized graphene oxide and dried it in a vacuum oven after centrifugation, and ground f-GO using mortar and pestle. But, after grinding, it still didn't...

28 November 2019 7,536 3 View

[Systematic Reviews] What to do if publication bias exist?

When doing the systematic reviews, if you I confirmed a publication bias during meta-analysis, my questions is what to do next? I though to add discussion about the publication bias, but I want...

17 November 2019 5,634 4 View

No title

26 October 2019 7,914 3 View

After a reference from Int J Body Compos Res, can any body help?

Hi, I am after the reference below, my library says it cannot obtain a copy either locally or internationally, any help appreciated! Chris Wang ZM, Heshka S, Wielopolski L, Pi-Sunyer FX, Pierson...

03 March 2021 6,193 1 View

Can we block unwanted images during the x-ray prediction?

i am try to classify the x-ray images. During classification , can i block unwanted images (except x-ray image).

03 March 2021 7,100 1 View

Does anyone know to clarify these changes?

01 March 2021 1,290 2 View

In an eye with Tyndall, does each dot correspond to an individual cell?

When you observe the presence of Tyndall in an inflamed eye: Does each of the small floating dots correspond to an individual cell or to an aggregate of cells? Does a conventional slit lamp have...

27 February 2021 6,326 2 View

How to calculate the crystallinity of cellulose film?

27 February 2021 2,753 4 View

What could be the reason for not having further low chi square value (better agreement) in my refinement result?

I have tried every combination of parameter changes and after that i have a poor chi square value. I can't get it lower any further. I know there have been a lot of discussion about Rietveld...

26 February 2021 8,480 3 View

Can anyone share his experience regards Smoothing in origin?

I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...

26 February 2021 8,183 3 View

How to replicate the well conditions of a crystal hit with 20%(w/v) isopropanol?

I had a crystal hit in a well with 0.1M HEPEs pH 7.5, 10%(w/v) PEG 4000, and 20%(w/v) isopropanol. Why is isopropanol in w/v here if it's just solvent? How do I recreate this well condition?

25 February 2021 9,761 1 View

I have need of XRD graph analysis software for phase identification. Can you please provide links for software tools which can be downloaded?

i am trying to download x'pert high score software, but can't download it. please do suggest software for phase analysis

24 February 2021 5,687 4 View

Why the CHi^2 is close to zero with a bad fitting but the Rp and Rwp are still high?

I am refining my XRD data using in FullProf program. The intensity of the modulated X-ray peaks is almost flat. I tried to adjust the peak intensities but unsuccessful. What is the reason? I guess...

23 February 2021 2,304 4 View