Hi,
How can I perform two way coupling of Eulerian – Lagrangian of turbulent boundary layer flow and particles in Fluent?
In addition, can I replace the terms of equation of motion of particles in Fluent?
Thanks for taking a look.
DPM mode ls Eulerian-Lagrangian Model available in Fluent. Also, one can add some terms or customize the terms in fluid motion by UDF.
I have modeled droplet evaporation and condensation using DPM model in Ansys FLUENT. you can add udfs for DPM laws, and alo energy sources, etc.
How can I leak detection pipeline in MATLAB
07 August 2017 371 6 View
How do I get data from wind turbine operation in ice conditions that I want to use for the FAST simulator?
07 August 2017 4,118 4 View
09 October 2016 7,651 10 View
04 May 2016 300 0 View
02 March 2015 123 5 View
Hi,I want to create a rectangular domain (L*B) with a large number of circles (over 6000) within it. The circles have different diameters, d, in specific ranges (i.e. d_min
07 August 2014 7,596 5 View
Hi, I know that FORTAN is fast, whereas one of disadvantages of MATLAB is the problem of speed. Matlab code is interpreted during runtime. Languages like C and Fortran are faster because they are...
10 November 2013 9,255 25 View
Hi, I want to simulate the flow field with high resolution turbulence, especially near the wall region. Thanks for taking a look.
06 July 2013 1,440 7 View
How to calculate the RMSD values for a MD simulation using MOE?
07 August 2021 0 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,
02 March 2021 0 0 View
Hello, I'm fairly new to ARENA and I have the following problem: I have two queues in which, in each queue, a different order type arrives (both having an arrival rate of exponential 10). Order...
02 March 2021 2,431 3 View
Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...
02 March 2021 4,910 3 View
Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...
02 March 2021 1,999 5 View