How to perform photo conductivity measurement for FINFET devices?
Please provide me the small signal model for finfet?
Check this link.
http://www.sciencedirect.com/science/article/pii/S0167931705001528
May be this would help you
Dear All, The neutron cross section of element generally falls with the increase in neutron energy. But in U-238 the fission cross section at Neutron energy of 1MeV is 0.3 barns whereas it...
02 March 2017 1,774 4 View
Is there any mathematical formula there for the ideality factor of the diodes? I will be very much thankful for the above. Please send the mathematical expression for it.
08 September 2016 7,007 5 View
In the radiation detector the pulse shaping circuit consists of CR-RC circuit and amplifier.The function of pulse shaping amplifier is to improve Signal to Noise ratio.It also act as a filter to...
08 September 2016 8,565 4 View
Generally there are three types of noise is present in the semiconductor radiation detector.These are Thermal Noise,Shot noise and Flicker Noise.The thermal noise is removed by operating the...
08 September 2016 9,355 2 View
Dear All, Is there any technique other than the CVD to coat the Enriched Boron-10 on the Si surface? I will be very much thankful for the reply. Thanks & Regards Manoj
08 September 2016 8,686 0 View
In the commercial available charge sensitive preamplifier for semiconductor radiation detector.Generally the HV(High Voltage) bias given to the semiconductor detector is through the charge...
08 September 2016 4,154 4 View
I have performed the neutron irradiation on the PIN Diode. I have found that the forward bias cut-in volatge has been shifted. Why these shift been observed in the neutron irradiated PIN...
06 July 2016 8,002 3 View
In the depletion region only uncovered ions are exiting then why we have the maximum electric field at the center of the junction?
06 July 2016 7,472 6 View
The function of the Guard ring is to reduce the leakage current and make the PIN diode to work at higher potential ? How does the guard ring perform this function? Please some one explain...
06 July 2016 6,690 2 View
Dear All, For the common mode signal the input voltage is calculated as (V1+V2)/2. Why we are calculating the common mode input signal as (V1+V2)/2 whereas in differential mode the input signal is...
04 May 2016 2,090 1 View
A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...
11 August 2024 9,801 2 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,493 1 View
How can I measure the thickness of thin film by Uv-Vis?
06 August 2024 7,810 3 View
Why is TLC not a form of partition chromatography and paper chromatography not a form of absorption chromatography?
03 August 2024 7,035 3 View
I need something like Camag's VisionCat software for photodocumentation of TLCs. Could you recommend something?
31 July 2024 8,415 1 View
I am attempting to conjugate PEG to an amino acid at the C-terminus, for the purposes of producing nanoparticles. I have been told that PEG modified with amine groups can be used for this purpose,...
31 July 2024 2,033 1 View
Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...
30 July 2024 906 2 View
What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?
29 July 2024 7,714 4 View
In some data sources it has been grouped in Q1 and some shows it is Q2.
29 July 2024 4,227 2 View
Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...
28 July 2024 5,771 2 View