You can do it in R after extracting the raw values from the xml output file. I can share the script i use if you want.

best,

Miguel

thank so much for your answer Dr Miguel Baltazar-Soares , Yes , i will try with R , you can send me the script, i will so grateful. Thanks again

To make graphs within Arlequin :

Make RcmD button in Arlequin active, by downloading.

Than take output in Xml format and immediately after press RcmD for making the graphs.

These graphs will appear within result folder , that is .res folder, in a sub-file as graphs.

Ameur Ameur Abdelkader just sent you.

Thank you so much Vindhya Mohindra , its very helpful,

Miguel Baltazar-Soares thanks again

I would appreciate if you could send me the script too. Thank you!

Francisco Boix

As a side note, anyone that might be interested in this just drop me a message - so I get the notification.

Thank you!

Hi Miguel Baltazar-Soares any chance you can send me the script also? Would be much appreciated!

Just sent you Alan!

can I get this script? Thanks in advance

Please Miguel Baltazar-Soares,

I would appreciate if you could send me the script too. Thank you!

Hey i will love to get the script so i can do it too, please

Please Miguel Baltazar-Soares,

I would appreciate if you could send me the script too. Thank you!

Miguel Baltazar-Soares

If you would be so kind as to send me a copy of the script as well, I would greatly appreciate it. Thank you!

Hey everyone, contact me by message because it is easier for me to notice the notifications.

best,

Miguel