I can use Fire Dynamic Simulator (FDS) For the fire simulation and model heat transfer and the structural analyses by Abaqus but i do not know how i link the results of FDS as an input file to Abaqus?
Dear Samira,
you can have a look at this paper: http://www.iafss.org/publications/fss/10/1465/view/fss_10-1465.pdf
There are commercial tool-kits for such a purpose: http://gem-innovation.com/project/afist/
Regards
Ruggiero
Hello,
you can link Matlab and Abaqus.
Regards,
Arash
Thanks Ruggiero,
I found AFIST previously but I could not download and use it. Is there any other way or software for linking of FDS or ABAQUS?
I'm working on 3D reinforced concrete column under cyclic loading and I need to consider the pinching effect. But I don't know how do it in Abaqus. Can anyone help me? thanks.
02 March 2015 4,959 3 View
I am modeling a reinforced concrete column under the heat transfer analysis in the Abaqus. According to the previous research related to my work, I modeled reinforcement as a wire geometry and...
01 February 2015 8,292 4 View
I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?
11 August 2024 3,115 1 View
I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...
10 August 2024 4,005 2 View
Usually, additive manufacturing techniques like SEBM, SLS, and SLM are used for interconnected porous lattice structure generation with sizes of >100–200 micrometers. Can the Fused Deposition...
09 August 2024 7,892 0 View
I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...
09 August 2024 5,048 2 View
I have input a moment load in module load Abaqus, i put my moment load on the node surface (using reference point). I have define moment in history output and make a set for moment too. But the...
08 August 2024 4,831 4 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
Dear fellow researchers, I am currently working on a paper where I need to provide a reliable reference that defines and distinguishes between 3D mesh models and 3D city models. Although I am...
06 August 2024 9,986 2 View
Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...
06 August 2024 1,989 3 View
is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it
06 August 2024 947 1 View