Hi,
Ι need some advice about COMSOL Multiphysics. I have a simulation set-up.
Specifically, Ι'm studying the transmission of a medium flow through a orthogonal parallelogram. I solved the problem, then I have the flow front pressures list.
I mention that the flow front will pass through every path point.
I need the pressure over time for every point from where the flow front will pass, (not just the value of flow front pressure over time).
How can I find that? Is there any idea?
P.S. I think that I must select to the Derived Values button of the result field. I think it would be proper then to choose Point Evaluation button. My problem is that I don't find a way to produce a group of values for a single point over time.
Thank you in advance!
Hi Panagiotis,
After you get a good solution to your problem. You can use '2D cut point' or '3D cut point' dependent on your problem which is just located under 'Results' tab-> 'cut point 3D' OR' cut point 2D'. Then you can choose any space point within your domain and show the corresponding solution result with the help of 'lD plot group'. Hope the above info. is useful for you.
Regards,
Liang
Yes what Cui told is correct
Results' tab-> 'cut point 3D' OR' cut point 2D'. Then you can choose any space point within your domain and show the corresponding solution result with the help of 'lD plot group'
How can I find the pressure over time for every point from where the flow front will pass using COMSOL? - ResearchGate. Available from: https://www.researchgate.net/post/How_can_I_find_the_pressure_over_time_for_every_point_from_where_the_flow_front_will_pass_using_COMSOL [accessed Mar 11, 2016].
- Badges
- Science topic