how can i extract the glacier mass balance data for any particular basin from the image given in "glacier mass balance over the PKH region by Kaab et al 2012
..
30 June 2024 4,031 3 View
Is there any way to find the lift force in CG motion udf? I need to to use in the vertical velocity. Here is the code I have written so far. The 2D airfoil is flapping, so I described a flapping...
15 April 2024 5,054 0 View
Hello I prepared silver nanoparticles by various method but every time peak disappeared, as the peak of silver nitrate salt at 300nm and it disappeared when I reduced it chemically. Now suggest...
06 February 2024 3,547 1 View
Bismuth ferrite (BiFeO3) is a well-known multiferroic material, meaning it exhibits both ferroelectric and antiferromagnetic properties. While it is primarily studied for its interesting magnetic...
14 January 2024 3,388 4 View
I am doing non linear direct integration time history analysis in etabs. To avoid convergence error, I used Hilber huges taylor parameter alpha value to be -1/12 instead of default 0. The analysis...
22 December 2023 6,061 1 View
I used the Linear polarization technique (Tafel Analysis) for corrosion measurement using Auto Lab. I studied corrosion at different current ranges from 1 mA to 100 nA, 1 mA to 1 microA, and 1 mA...
09 December 2023 2,865 3 View
Using Abaqus, I need to simulate the tensile test of carbon/flax hybrid twill woven composites. I need to use failure criteria also. Can Hashin criteria be used in this? Also, I need some guidance...
21 November 2023 7,070 0 View
I have to do trnd analysis using mann kendall test.
14 November 2023 2,486 2 View
URGENT!! I'm working with facultative anaerobes. i have used anaerobic jar for incubation. do i need to use anaerobic jar for biochemical tests? please help
07 September 2023 2,601 1 View
I am projecting sreamflows for my study area for which i have considered the average values. In most of the studies instead of average, the researchers have considered the median values for...
31 August 2023 733 5 View
Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...
11 August 2024 8,141 3 View
I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...
10 August 2024 8,539 5 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
Hello experts, Does anyone know any free software about retention index prediction ?
08 August 2024 7,403 2 View
I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...
08 August 2024 8,329 0 View
Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...
07 August 2024 9,563 0 View
I am Looking for a Science Journal with good impact factor and low publication cost to publish a review paper. Your suggestions would be appreciated.
06 August 2024 6,796 3 View
I received an e-mail invitation to join the editorial board of Clinical Cardiology Updates. While I have published a few articles related to cardiovascular disease, there are lots of colleagues...
06 August 2024 8,981 8 View
Palmitic acid presence in aqueous fraction
05 August 2024 8,624 4 View
If the placenta is delivered in squatting position within 3 minutes of the birth of the baby, postpartum hemorrhage is completely eliminated. It works every time. It is quite likely that if a...
05 August 2024 8,895 0 View