How can I convert atm/M into atm/mole fraction?

Nishtha Dhunnoo @Nishtha_Dhunnoo

02 February 2016 0 4K Report

Henry’s Law:

Coxygen = K Poxygen

The K value for oxygen at 25 oC is 1.3 x 10-3 M/ atm

How should I proceed to obtain the following? :

1.3 x 10-3 atm/M = 0.07222 atm/ mole fraction

Badges
Science topic

More Nishtha Dhunnoo's questions See All

Where can I find a standard procedure for reverse osmosis membrane autopsy?

I am going to perform a membrane autopsy of a reverse osmosis membrane to investigate fouling. I know how to do it based on research papers that i have read but I need a standard procedure...

04 May 2018 4,724 2 View

CIP (Clean in place) system design for RO (reverse osmosis membrane) cleaning?

Are there any books or research papers which can help me in designing an RO CIP cleaning system please?

11 December 2016 724 1 View

Importance of maintaining the record of Material Safety Data Sheets (MSDS) of chemicals being used at the work place?

What is the importance of maintaining the record of Material Safety DataSheets (MSDS) of chemicals being used at the work place.

10 November 2016 3,809 3 View

How can i simulate cleaning process using sponge ball in heat exchanger?

I have values of fouling factor varying with time. How can I show the effect of sponge ball/ projectile cleaning on fouling factor? is there any calculation or simulation i can do?

09 October 2016 3,032 0 View

Multi stage flash distillation & multi effect evaporators in sea water desalination?

What are the specific types of evaporators used in multi stage flash distillation and multi effect evaporators in sea water desalination? such as parallel flow, cross flow...etc. and such as plate...

08 September 2016 9,418 1 View

Can you please send me a link where I can download Aspen software?

Even if it is a trial version. I need it to model fouling in heat exchangers

08 September 2016 9,837 11 View

IDA Desalination Report 2016?

Hello if someone has the IDA Desalination Report 2015-2016, can you please send me? I need it for my undergraduate dissertation. I will be very grateful. I have searched online, it is not...

07 August 2016 9,214 1 View

Are there any software which is used in desalination plant to monitor fouling and scaling?

Are there any software used in desalination plant? and can it be used to monitor or prevent fouling and scaling?

07 August 2016 5,472 3 View

How do I proceed with the following calculations on chemical process design?

The following attached questions are from the book Introduction to Material and Energy Balances by Reklaitis. How do I proceed to solve the questions? Can I get the worked solutions please

04 May 2016 9,327 1 View

How do i proceed to find the column reduction of a matrix?

I need to find the column reduction form of a matrix. Are there any easy methods, free online books or pdfs where I can get examples?

04 May 2016 8,058 3 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

Is it possible to plot the atom-projected band structure using GPAW?

Hi, I'm currently working on a project where I need to plot the atom-projected band structure using GPAW. I've been able to calculate the band structure for my material, but I'm having trouble...

07 August 2024 269 3 View

Should I remove an item from a scale to raise Cronbach's alpha and McDonald's omega or is it better to leave it if they are both over .7 already?

Hello! I have this scale which had 10 items initially. I had to remove items 8 and 10 because they correlated negatively with the scale, and then I removed item 9 because Cronbach's alpha and...

01 August 2024 4,606 7 View

Why 3 replicates for most biological assays? Is it enough to examine the data fits normal distribution?

Just bounced on me. Before statistically analysing significant difference, shouldn't we see if data fits normal distribution first? Is 3 replicates enough to testify the hypothesis of normal...

31 July 2024 8,141 13 View

Posthoc test lettering in JAMOVI?

Does anyone know of a module for the JAMOVI software that is capable of generating mean separations using the classic letters based on post hoc results (e.g., Tukey test)? If, as I believe, such...

31 July 2024 3,333 4 View

Inquiry on Maximum Nucleic Acid Volume for 2.5 mL Liposome Solution?

I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...

30 July 2024 6,420 1 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

What is the best method to detect the chemical composition of pollen ?

I have multiple small samples of grass pollen with anthers. I want to find a method to identify concentrations of proteins, lipids, and other various elements for these samples. any suggestions?

28 July 2024 5,331 1 View