How do I proceed with the following calculations on chemical process design?

05 May 2016 1 9K Report

The following attached questions are from the book Introduction to Material and Energy Balances by Reklaitis. How do I proceed to solve the questions? Can I get the worked solutions please

Brian Hanley

Time to do your own homework.

Badges
Science topic

Similar topics
Engineering

More Nishtha Dhunnoo's questions See All

Where can I find a standard procedure for reverse osmosis membrane autopsy?

I am going to perform a membrane autopsy of a reverse osmosis membrane to investigate fouling. I know how to do it based on research papers that i have read but I need a standard procedure...

04 May 2018 4,724 2 View

CIP (Clean in place) system design for RO (reverse osmosis membrane) cleaning?

Are there any books or research papers which can help me in designing an RO CIP cleaning system please?

11 December 2016 724 1 View

Importance of maintaining the record of Material Safety Data Sheets (MSDS) of chemicals being used at the work place?

What is the importance of maintaining the record of Material Safety DataSheets (MSDS) of chemicals being used at the work place.

10 November 2016 3,809 3 View

How can i simulate cleaning process using sponge ball in heat exchanger?

I have values of fouling factor varying with time. How can I show the effect of sponge ball/ projectile cleaning on fouling factor? is there any calculation or simulation i can do?

09 October 2016 3,032 0 View

Multi stage flash distillation & multi effect evaporators in sea water desalination?

What are the specific types of evaporators used in multi stage flash distillation and multi effect evaporators in sea water desalination? such as parallel flow, cross flow...etc. and such as plate...

08 September 2016 9,418 1 View

Can you please send me a link where I can download Aspen software?

Even if it is a trial version. I need it to model fouling in heat exchangers

08 September 2016 9,837 11 View

IDA Desalination Report 2016?

Hello if someone has the IDA Desalination Report 2015-2016, can you please send me? I need it for my undergraduate dissertation. I will be very grateful. I have searched online, it is not...

07 August 2016 9,214 1 View

Are there any software which is used in desalination plant to monitor fouling and scaling?

Are there any software used in desalination plant? and can it be used to monitor or prevent fouling and scaling?

07 August 2016 5,472 3 View

How do i proceed to find the column reduction of a matrix?

I need to find the column reduction form of a matrix. Are there any easy methods, free online books or pdfs where I can get examples?

04 May 2016 8,058 3 View

What is the diameter to length ratio of a deaerator tank?

I need many references. are there any books or links where I can find the above?

01 February 2016 2,442 1 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

I have get this error when i calculated the geometrical optimization for prco3, it takes 12 hours until gives this message in the outputfile?

Fatal error in MPI_Allreduce: Other MPI error, error stack: MPI_Allreduce(1628)......: MPI_Allreduce(sbuf=000002459254A180, rbuf=000002459F86A140, count=4851, MPI_DOUBLE_COMPLEX, MPI_SUM,...

09 August 2024 7,615 1 View

How to develop investments in renewable energy sources?

08 August 2024 5,112 3 View

How to confirm the site-directed mutagenesis result without performing NGS?

I'm cloning a fragment of 3200 nts into plasmid. The cloning was successful, however, 02 amino acids were mutated. Now I want to fix these 02 aa by site-directed mutagenesis technique using...

08 August 2024 4,645 2 View

GC-MS retention index prediticon?

Hello experts, Does anyone know any free software about retention index prediction ?

08 August 2024 7,403 2 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

Is it possible to plot the atom-projected band structure using GPAW?

Hi, I'm currently working on a project where I need to plot the atom-projected band structure using GPAW. I've been able to calculate the band structure for my material, but I'm having trouble...

07 August 2024 269 3 View

What is the prepared reference material that can be used in inductively coupled plasma optical emission spectrometry (ICP-OES) to measure REE and U ?

What is the prepared reference material that can be used in the ICPE-9820 Shimadzu Japan instrument, which employs inductively coupled plasma optical emission spectrometry (ICP-OES) to measure...

06 August 2024 1,896 1 View

Research Methodology - Impact of Corporate Reputation on Stakeholders Behaviors?

Please can anyone support with the survey questions based on RQ measures and propose how to do it in FMCG industry and include as well the role of brand equity Thanks

06 August 2024 949 0 View