The quantitative measures of surface roughness are extracted in the spatial frequency domain using the 2D FT. The FT approach has the desirable properties of noise-immunity, orientation dependency, and enhancement of periodic features.
Much industrial related solution has been integrated but considering the periodic problem formed even after proper steps are taken. In maintenance engineering practices like preventive maintenance...
09 October 2019 4,597 1 View
The forced convection system requires long heat up time, high energy consumption, large floor area and some additional setups for air circulation inside the oven. Infrared radiation heating will...
06 July 2019 8,572 2 View
Setting Time Reduction is the method of dropping changeover time that is start from last good piece of previous run to opening good piece of subsequent run. Seeing as setup performances add...
02 March 2019 8,516 2 View
Both ANN and fuzzy system (FS) are used in ANFIS architecture. The integration of ANN and FS has demonstrated the potential to extend the technologies when applied individually. The two systems...
31 December 2018 1,961 0 View
The quantitative measures of surface roughness are extracted in the spatial frequency domain using the 2D FT (Two Dimensional Four Year Transform). The FT approach has the desirable properties of...
31 December 2018 9,560 3 View
An ANN is a parallel, distributed information processing structure that mimics the human brain to learn from examples or mistakes
11 December 2018 5,390 1 View
I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...
10 August 2024 8,539 5 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
Hi all, my experimental XPS results shown that my C3N5 sample consists of N-H bond, hence in this case I should incorporate the N-H bond into my DFT modelling. However, I do notice several papers...
07 August 2024 8,414 2 View
Palmitic acid presence in aqueous fraction
05 August 2024 8,624 4 View
I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...
03 August 2024 4,725 2 View
I am conducting a systematic review and meta analysis; as I am extracting data I realized there is a consort diagram that shows the number of patients from randomization till end of the study. So...
01 August 2024 9,993 3 View
99% pure ethanol was used for maceration also alternate methods along with the temperature and time to concentrate the extract can be specified
31 July 2024 5,113 4 View
We conducted an antibacterial study of a plant extract. Varying concentrations of crude extract were subjected to microbroth dilution assay. The result showed that only the lowest concentration of...
31 July 2024 8,666 3 View
I am currently investigating the cytotoxicity of a series of herbal extracts, and like many studies, I have been using the MTT assay to evaluate cell viability. However, I am encountering a...
31 July 2024 193 4 View
I want to do wavelet transform of some compounds for their comparative study? Kindly help me in this regard and provide with proper procedure.
31 July 2024 4,170 0 View