High speed flows can be simulated with what type of solver that disregards viscosity?

More Arun P Jose's questions See All

How to remove the air bubbles in comercially available ultrasound gel?

The ultrasound gel which is commercially available contains lot of air bubbles.Which creates lot of noise while scanning. How to avoid the air bubbles in the gel such that the scan wont have much...

11 December 2019 9,946 2 View

How can we test the presence of Bacteria?

If a product is fabricated to eliminate bacteria in dress using uv lights how can we test the effectiveness of the product

08 September 2017 1,089 3 View

How to specify material properties for Eulerian-Eulerian multiphase model in fluent ?

I am analyzing the copper water nano fluids in fluent by multi phase Eulerian-Eulerian approach.i want to describe the material properties of copper nano paricle which are dispersed in water.i...

03 April 2016 6,204 14 View

What will be vibrational frequency exerted by the road on the tyres?

I am designing a wheel chair i want to test my design using ansys workbench harmonic response.So what are the parameters i should describe, especially the frequency range for the surface...

03 April 2016 8,893 2 View

What is the viscosity of copper nano particles?

I am doing a simulation in fluent i am using eulerian -langragian model i want to provide the material properties for secondary phase which is copper nano particle

03 April 2016 2,753 2 View

How to specify volume concentration in ansys fluent 16???

I am currently doing a project on convective heat transfer in nanofluids.my geometry is a 2D circulartube. how to specify the volume concentration of base fluid and secondary fluid in multiphase...

02 March 2016 3,060 4 View

How to plot the fluid temperature and wall temperature of a fluid flowing through a pipe in ansys fluent 16??other than taking locations

laminar flow of water is considered

02 March 2016 8,435 0 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

How to determine positive-stained cells in FACS? Use isotype or unstained control?

To compare positive and negative cell populations in flow cytometry, should I compare unstained cells with antibody stained cells? Or with the isotype control? Most papers show comparison with...

06 August 2024 6,728 6 View

Why do we equate male and female arousal?

Women, on the other hand, can become physically aroused (increased blood flow in the reproductive organs) without becoming psychologically aroused even in the slightest. (Robert Weiss)

05 August 2024 9,537 2 View

When I simulate for S parameters using ADS, I have faced this issue that I have attached. Please anyone clarify me?

...

31 July 2024 1,671 3 View

How to make a Lateral flow control line more uniform?

We have a lateral flow test on Sartorius 140 NC. The conjugate is gold-monoclonal antibody. Using different control lines (GAM, protein A, protein G) we get a very strong leading edge with reduced...

31 July 2024 4,510 3 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

Suggestions for the Annexin V Positive Control ?

Hello everyone, I am currently using washed human platelets to stain Annexin V as a procoagulant marker. Additionally, I am staining with PerCP-CD61 to identify platelet cells. So far, I have...

29 July 2024 8,624 1 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

Why cannot i find my protein on cell surface after antibiotic selection of expressing plasmid?

I cannot confirm cell surface protein expression by flow cytometry even after transfection and antibiotic selection of cells. Does it take long for proteins to express on the cell surface? the...

28 July 2024 3,178 3 View

Panchatcharam Mariappan

Do you mean the superfluidity problem? OpenFOAM can do high speed flows simulation.

Sakir Bal

OpenFOAM. (Euler solver )

Shiuh-Hwa Shyu

If you are referring the gasdynamic problem, use TVD like scheme.

Adarsh Vasa

I got this as a random question CAPTCHA while registering to CFD online. I tried using OpenFOAM as my answer but it was incorrect.