Here is an article motivating the development of a specialty called Statistical Medicine. Is this really necessary?

More Shola Adeyemi's questions See All

Please, is there suitable solvent to fractionate fatty esters into medium molecular weight fatty esters and high molecular weight fatty esters?

I want to separate a complex mixture of esters into medium and high molecular weight esters using solvent extraction.

11 October 2020 9,891 2 View

Can You Recommend good tutorial materials and literature on grid forming and grid following converter models?

Can anyone recommend good tutorial materials and literature on 'grid forming and grid following converter models'?. I will appreciate your recommendations and suggestions. Thanks.

02 July 2020 9,374 3 View

Is there any open source software available to model the microstructure of cementitious composites?

I will like to model the microstructure of concrete/mortar, is there any software to model the resulting products? Thanks

20 January 2019 1,099 2 View

What is the best way to coat PVA fibers with oil agent?

PVA fibers are modified with oiling agents to reduce bonding between the fiber and the cementitious matrix. What is the best type of oiling agent and method of application is most...

05 December 2018 2,055 1 View

How to get percentage contribution of factors in design expert?

I'm using design expert software for the design of the influence of different factors in my experiment. However, I couldn't get any section that shows the percentage contribution of each factor on...

29 November 2018 6,125 3 View

Is there any non destructive test that can be improvised in the lab to estimate the strength and permeability properties of concrete?

Non destructive tests equipment for concrete are quite expensive and not readily available. Is there any non destructive test that can be improvised or built with commonly available materials to...

27 November 2018 5,552 3 View

What are the emerging supplementary cementatious materials that can be used to replace cement?

The use of supplementary cementitious materials (SCMs) is increasing rapidly as they can be used to partially or totally replace OPC in concrete. The most common types of SCMs are fly ash, slag,...

25 November 2018 9,400 12 View

Why is high volume slag associated with high shrinkage in cementitious composites?

I will like to know why there is always high shrinkage when slag is used at larger percentage replacement of cement. The reasons in terms of its chemical reactions with OPC and the physical and...

22 November 2018 9,609 3 View

Can you suggest a PhD research topic in Renewable/Sustainable energy?

Fellow Researcher can you please suggest a relevant PhD research topic in Renewable/Sustainable energy Systems? I'll appreciate if you can help me identify a clear problem and an incline to the...

21 November 2018 8,162 17 View

How to improve the sustainability of ECC?

Engineered cementatious composites are high performance composite and are gaining huge research recently due to their enhanced ductility and durability. What are the major ways to improve the...

18 November 2018 6,898 14 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

Which is better medicine or food in obesity?

Preference in terms of the scientific aspect

28 February 2021 796 2 View

VIF very high, but correlation is low and coefficient is significant. Which one whould I choose?

Hello. I have a question whether if my coefficients (statistically significant) would be valid when VIFs are really high. In my model, there are independent variables(IV), moderating variables...

26 February 2021 956 13 View

Data Analysis K-S and S-W tests?

Hello, I have conducted analysis where the K-W and S-W have come out as p

25 February 2021 9,648 3 View

Statistics: include groups of respondents made by one person for analysis?

Good morning, I could not find literature about this so I am asking. I am organizing data for a questionnaire (N=100) that foresees some personal questions like level of education. For the aim...

25 February 2021 2,090 4 View

How to use Remote sensing and GIS applications for mapping the available medicinal plants within the locality/municipality?

Hello, I'm very interested in mapping and managing the conservation of the Philippine traditional medicinal plants, in which I think is very helpful in the field of medicine for further analysis...

21 February 2021 374 5 View

Which is the best software or programming language (user friendly) for analysing data?

I have a basic knowledge on Python, R and MATLAB in analysing data. Among those, which is the best and user friendly? Which one should I learn deeply to analyse data?N:B: I want to learn data...

20 February 2021 3,950 15 View

Is the box plot of climatic indices better illustrate from daily data or annual data?

Hello, I hope you have a good time. I work on a research project about temperature indices. Due to the high number of indices, I only work on tables and maps on an annual time scale. In other...

19 February 2021 9,742 2 View

Ashique Ali

The full article is not available let me read it completely then I can comment on the article but as for as topic of statistical medicine is concerned it does not suit . Statistics is a part of research and evaluation it is not medicine it can be applied in various fields

Dennis Mazur

One could well argue that the importance of statistics in today's data-driven medicine could use further support like Statistical Medicine to help those who have not as yet developed sufficient statistical interpretative skills in their own research careers. .

Dennis