For a multiport antenna I have farfield data in form of H-co, H-Cross, E-CO and E-cross, for some frequencies, How can I calculate the ECC?

Rahul Porwal @Rahul-Porwal-4

27 July 2023 0 3K Report

I need to calculate ECC from farfield data.

I have data of radiation patterns for H-Co, H-Cross, E-Co and E-Cross at some frequencies.

Can anyone tell the method to calculate ECC using farfield data.

Badges
Science topic

More Rahul Porwal's questions See All

In PRIMER, is it possible to downweight certain taxa in multivariate community datasets to reflect uncertainty around identification??

I have a dataset with about 80 different species. As usual, some species are very easy to identify with certainty whereas others are more difficult, which means that I am less certain of my...

03 March 2021 8,066 4 View

How to get onecolumn document from standard IEEE ACCESS LateX template?

I have prepared a manuscript in IEEE Latex template, but for some purpose, I need to prepare a word file as well (detailed format is not required). Compared to two column .tex file, one column...

02 March 2021 1,830 3 View

Gel electrophoresis result for total RNA samples, 1.5 Agarose gel was used, How to improve the integrity of RNA?

Gel electrophoresis, RNA degradation, RNA extraction from fresh tissue

02 March 2021 5,433 5 View

How to grow E.coli on the low salt LB agar plate with 50 or 100ug/ml of Blasticidin?

Hello, I would like to ask how to grow E.coli which resists 50 or 100ug/ml of Blasticidin. I have tried many methods by using low salt Luria-Bertain(LB) agar plate. However, no colonies grow. Let...

01 March 2021 2,027 2 View

OpenBCI eeg--has anyone used them?

I'm looking to try out an off-the-shelf EEG set for some exploratory work. Curious if anyone has used the OpenBCI, and how much set-up work is required. I've heard they are more difficult to get...

01 March 2021 4,128 3 View

How to remove DCU and HOBT from my reaction?

I am doing a acid and a chiral amino alcohol reaction using DCC and HOBT in DCM or THF? Can anyone suggest me how to remove DCU and HOBT from a reaction mixture??

28 February 2021 2,153 1 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

B-mercaptoethanol (BME) protocol?

Hi everybody, I have been running a multiplex IHC which allow me to stain the same tissue with different markers (Primary Ab + Secondary conjugated Ab) (AF487, AF555, AF647). Since I would like to...

27 February 2021 5,028 2 View

What is the suitable range of Sulfur content and Viscosity of Heavy fluid Oil that used in Kiln?

What is the disadvantages of high sulfur content to the ceramic burning process? and what is the effect of outranged viscosity?

24 February 2021 8,219 2 View

Is IMAGE ENCRYPTION using ECC a good research area?

There have been existing works like Singh and Singh(2015) and subsequently one in 2017 that performed Image encryption using ECC. But I have been seeing ppl comment that encryption with ECC is not...

14 October 2020 4,479 5 View

How to perform image encryption using ECC in matlab?

I am looking for an image encryption code using elliptic curve cryptography so as to understand how it's done.

30 August 2020 7,407 3 View

How to calculate ECC using HFSS software?

Good morning. Now i am designing MIMO antenna for Ultraband Applications. Can anyone suggest how to plot ECC (Envelope correlation Coefficient) Using HFSS 15 software. Thanks in advance

13 February 2020 5,261 6 View

How can the image contrast in SEM between individual grains of (presumably) single-phase material at low acceleration voltages be explained?

Recently I observed a comparatively strong contrast between grains in SEM micrographs of Yttria-stabilized Zirconia (3YSZ). Microstructure is shown in the attached file. Both samples had been...

12 January 2020 4,869 3 View

Any one can help me? How can I implement any encryption algorithm in Ifogsim?

I am working my research in fog computing and I choose Ifogsim Simulator, so I need to implement the security part of my work using NTUR and ECC Encryption algorithm. Any one can help me is it...

09 October 2019 5,509 2 View

Is it possible to implement ECC bilinear pairing in WSN?

14 July 2019 6,438 28 View

Is it possible to implement ECC bilinear pairing in WSN?

06 July 2019 9,651 6 View

How to model ECC in ANSYS ?

where to incorporate the tensile strain hardening properties of ECC

03 April 2019 2,797 1 View

Any Guideline to be followed for micro mechanical modelling of ECC with Hybrid fber reinforcement?

Fibers are with different modulus of elasticity

31 December 2018 2,470 1 View

What is the best way to coat PVA fibers with oil agent?

PVA fibers are modified with oiling agents to reduce bonding between the fiber and the cementitious matrix. What is the best type of oiling agent and method of application is most...

11 December 2018 6,141 1 View