Run time is getting too high for the analysis for the attached model. Please let me know any possible option to modify the model in a way reduce the run time while keeping the accuracy at the same time...
Dear Mangala,
The computational running time depends on various parameters such as mesh size, element type, loading, and step time. I suggest you perform the mesh convergence tests prior to analyze or you may use a coarser mesh to optimize the running time.
Best regards,
Dear Mangala
Your software must be licensed for efficient analysis. If the software you are using is a student version or a cracked's software, it will be limited. However, make sure that you have defined the boundary conditions correctly. Moreover, you can increase your mesh size. Smaller mesh size required computing time longer than coarse mesh. Besides, if there is one symmetry line in your model, you can analyze half (1/2) of the model. If there are two lines of symmetry, use the quarter (1/4) of the model only.
Thank you.
Dear Sir Bekhzad Yusupov inp file is attached herewith. Please be kind enough to let me know any possible option to carry out.
- Badges
- Science topic
- Similar topics
- Biological Science
- Kinesiology
- Running