Does having 2 absorption edges in UV Vis spectrum means that the heterogenous composite is not subjected to highly efficient heterojunction?

2 weeks ago 1 6K Report

Hi,

Does having 2 absorption edges in UV Vis spectrum means that the heterogenous composite is not subjected to highly efficient heterojunction? I have a composite made up of g-C3N4 and TiO2. Most researchers reported that only 1 absorption edge was observed in the UV Vis spectrum for the same composite. But I found that my composite has 2 absorption edge. Why?

Abdelhak Maghchiche

Two absorption edges in a g-C3N4/TiO2 composite UV-Vis spectrum reflect the distinct band gaps of each component, indicating incomplete electronic coupling rather than necessarily inefficient heterojunction formation.

Badges
Science topic

More Syazwani Suhaimi's questions See All

Why PEGDA hydrogel produced by emulsion polymerization became viscous and sticky?

Dear all, currently I am facing problem with my synthesis to produce PEGDA hydrogel by emulsion polymerization. I'm using PEG, Benzene, TEA, AcCI and Nitrogen gas for the experiment. Unfortunately...

18 May 2023 6,561 0 View

Hydrolysis in solvothermal of TiO2?

A very good day to all of you. I have a question regarding solvothermal preparation of TiO2. Is hydrolysis rate is important in the solvothermal process? Is it bad or good? How does the acidic...

21 December 2022 123 2 View

What are the products of the reaction between TTIP and ethanol?

Can someone tell me what are the products of the reaction between TTIP and ethanol? does it include isopropyl alcohol?

10 November 2022 5,745 0 View

Is it possible for regression analysis not significant even if these variables correlate?

i have done a spearman correlation analysis and all of my independent variables correlated with the dependent variable. However, when i did multiple regression analysis, the results show the iv...

10 November 2022 1,475 6 View

What is the best method to produce TiO2 through solvothermal synthesis?

Hello. I have question regarding TiO2 solvothermal synthesis. I used TTIP as the TiO2 precursor and ethanol as the solvent with ratio of 70:30 (TTIP : ethanol). The solvothermal product was...

09 November 2022 9,083 2 View

Does an ultrosonic vocalization analysis compulsory for the evaluation of neonatal abstinence syndrome in animal pups?

Can we exclude the ultrasonic vocalization from the list of parameters of neonatal abstinence syndrome?

18 October 2022 7,628 0 View

What is different between plastic nebulizer and stainless steel nebulizer for atomic absorption spectroscopy?

I am testing MgO nutrient in fertilizer sample. I observe that there are difference between result when using different type of nebulizer.

10 January 2021 5,140 4 View

What can I do to increase my Atomic Absorption Spectroscopy performance?

I am analyzing concentration of MgO and K2O in fertilizer using AAS. I always got issue with my result is lower than specification.

10 January 2021 1,122 14 View

Relationship between price and marginal cost and what does affect the generation?

There are some constraints that should be considered in generating electrical power. Example of constraints such as Generator’s Output Limits, Piecewise Linear Cost Function, No-load Cost, Start...

21 March 2020 5,917 3 View

Is there any SOP to measure pharmaceutical clean room and if none can we develop our own method to measure the room size?

In order to reach a desired cleanliness level inside the cleanroom, the HVAC system combines air changes per hour (ACH) with HEPA filtered air circulating into the cleanroom many times per hour. ...

06 March 2020 1,149 1 View

Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

Baseline drift in HPLC? What causes this?

Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!

11 August 2024 3,770 4 View

What is the prepared reference material that can be used in inductively coupled plasma optical emission spectrometry (ICP-OES) to measure REE and U ?

What is the prepared reference material that can be used in the ICPE-9820 Shimadzu Japan instrument, which employs inductively coupled plasma optical emission spectrometry (ICP-OES) to measure...

06 August 2024 1,896 1 View

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

How can I add own Henry coefficients in Aspen Plus?

Hi, i would like to simulate an absorption process in Aspen Plus. I want to use the NRTL model und would like to add some individual Henry coefficients. Is that possible and how?

05 August 2024 2,333 2 View

Why might the impedance values for DI water and 0.1X PBS buffer solution exhibit a decreasing and increasing trend, respectively over time (HP 4194A)?

Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...

05 August 2024 3,783 2 View

Could dyes amplify the spectrum of light to a specific wavelength?

I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...

05 August 2024 3,290 1 View

Why is TLC not a form of partition chromatography?

Why is TLC not a form of partition chromatography and paper chromatography not a form of absorption chromatography?

03 August 2024 7,035 3 View

Can a Conventional 50W visible LED Lamp Emit UV Light?

I'm researching light sources and their UV emissions. I'm curious if a 50W, 7500K conventional LED lamp emits any UV light. I found that a 200W tungsten lamp can emit up to 1.5 mW/cm² at 350 nm....

31 July 2024 3,843 7 View

Mossbauer spectroscopy Co0.6Mn0.4Fe2O4 MNPs?

Following curve related to Co0.6Mn0.4Fe2O4 Magnetic nanoparticles with extra phase a-Fe2O3. I will appreciate to help me to interpretation this spectroscopy, especially the blue line.

31 July 2024 9,140 2 View