Does anyone know the R codes for .632+ bootstrap?

More Maz Jamilah Masnan's questions See All

How to prepare zicronia as filler in polymer?

Good day to all. I need advice on preparing nano zirconia in polymer. After inside the zirconium precursor with acetone,water and acid, I cast my mixture but then in few day I notice that white...

24 March 2017 7,202 4 View

How to prepare nanopowder?

Good morning to all. I need advice on preparing nanopowder. After mixing the precursor with solvent, water, and acid, I cast my mixture. Then I dried in at room temperature for few day. Then I put...

15 February 2017 6,554 5 View

Can I combine fungi culture or fungi extracts to produce active compound or hits against ESKAPE?

As we know that we try to isolates endophytic fungi from plant that have medicinal use.But,after isolates the fungus,we try to ferment and get the compound from it and found out that there are no...

07 September 2015 5,320 3 View

Is there any method or skill to make a microfungi specimen on plate just like a herbarium made by a botanist?

Usually, it's very hard to identify fungi based on its morphology. It is easy if i have specimen of fungi culture to refer to, instead of referring to fungi plate photos. If there any, i would to...

23 August 2015 6,475 9 View

Why are some protons not detected in HNMR?

My compound (quercetin) contains 10 proton and supposed to shows 10 different chemical shift. but the HNMR only shows 8 peaks which is shows 8 different chemical shift. can anyone help me with...

15 April 2015 3,982 5 View

How do I extract of secondary metabolites from fungi (microfungi on plate) in water?

I've been using agar plug method for antimicrobial primary screening against E.coli. There is a fungus that shows activity against the E.coli. This means that the fungus has the potential to be...

28 December 2014 3,945 8 View

What is the best way to identify the most relevant/sufficient features for classification?

Say we have a set of features that are highly correlated to each other. We know that in this situation, features are redundant. Our interest is to retain features that are important for further...

22 April 2014 1,195 14 View

How to define an anisotropic material with asymmetric elastic compliance/stiffness matrix in ANSYS APDL?

I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...

09 August 2024 5,048 2 View

Request Python code?

Request Python code from this article : Gender equity of authorship in pulmonary medicine over the past decade. THANKS!

08 August 2024 6,242 2 View

GC-MS retention index prediticon?

Hello experts, Does anyone know any free software about retention index prediction ?

08 August 2024 7,403 2 View

Why does everyone use vs code?

Visual Studio Code (VS Code) has become a popular choice among developers for several reasons: 1. **Free and Open Source**: VS Code is free to use and open source, making it accessible to...

07 August 2024 7,013 4 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

If we are using snowball sampling technique, how do we justify the true representativeness of the sample statistically? is there any statistical test?

Are there any statistical methods to justify your sampling technique using SPSS or AMOS?

05 August 2024 9,153 4 View

How can i do multivariate Time Series forecast using MLP, ANFIS and LSTM?

I need the python code to forecast what crop production will be in the next decade considering climate and crop production variables as seen in the attached.csv file.

05 August 2024 2,977 3 View

How to report results of Generalised Linear Mixed Models in a journal article?

Hi everyone, If you have written or come across any papers where Generalised Linear Mixed Models are used to examine intervention (e.g., in mental health) efficacy, could you please share the...

04 August 2024 4,130 4 View

Which test should be used to study association among demographic profile and awarness level?

i have to study the awareness and adoption level of cloud computing in a district of India. i also want to use association among demographic variables like gender, age, education, income etc and...

02 August 2024 2,420 3 View

Can anyone provide me with molecular docking softwares/ websites?

Molecular docking software/ websites?

02 August 2024 8,704 7 View

José M.C. Pereira

Hi,

Have you tried the R package 'sortingthat': http://cran.r-project.org/web/packages/sortinghat/sortinghat.pdf

It includes the .632+ estimator to evaluate the performance of classifiers.

Maz Jamilah Masnan

Thank you very much for responding and the suggestion. I have checked the site you proposed. Its a great help. Thanks again!

Samuel Granjeaud

The source code is always at https://github.com/ramhiser/sortinghat/tree/master/R

Sounds great.