Hi Narges Meftahi,

The Qualisys Track Manager (QTM 2.12) is a software for capturing and tracking of markers according the model that you determine, but if you want to see another synchronized data such as EMG or Force plates you should be using a software for processing data such as Visual 3D or Matlab, and you will see all data and processing.

But if you want to see data only export data to C3D and read it by any of free programs such as Visual 3D reader (in attachment).

Best regards,

Abdel-Rahman Akl

Thanks dear Abdel-Rahman for your suggestion. Exporting data to C3D didn’t work because there is no recorded data by EMG. I did it but there is no EMG data and no graph in Visual 3D, too.

Check to see that you enabled your a/d board. And also check that you checked the analogue boxes for export .

also in qtm on the left pannel there is a data info window where you can see all the raw data including and forceplate , emg , or other analogue data. You need to expand thqt window.

Hi Narges Meftahi,

Ok, you can check if you already recorded EMG or not by:

1- when you open the project of QTM press ctrl+D, an window will appear beside the left panel.

2- on this window right click and display analog.

3- select EMG channels and right click, select plots, then voltage.

You will see if you recorded or not.

Best regards,

Abdel-Rahman Akl

Hi,

Thanks for your suggestions.

I did all these steps but no voltage plots were shown.

From what I read I understand that you can see the measurement but you can't record it? how do you trigger them both at the same time?

My answer would be to check if the memory is not full and how it exports data. there might be the possibility that Mega ME6000 only displays the values but it doesn't records them.

Check in the menu, settings.

Please vote if you find this useful, and also answer my questions.