Does anyone have idea about needle proof glove?

Subasgar Kumareswaran @Subasgar_Kumareswaran

10 October 2014 1 5K Report

Does anyone have idea about how to make a needle proof glove and which kind of latex or fabric is used?

Victor H Ponce

Please take a look at the turtleskin website, you can get some ideas from it.

http://www.turtleskin.com/Index.aspx

Badges
Science topic

More Subasgar Kumareswaran's questions See All

How to find the concentration of acetic acid in the organic solvent?

I need to find out the concentration of Acetic acid in Xylene by using titration (NaOH - Phenolphthalein) but I couldn't get accurate result please suggest a proper method.

05 June 2019 9,700 5 View

What is the correlation among degradation of NR gloves, TiO2, Xylene and Acetic acid?

In supported NR glove industries, mixture of xylene and acetic acid is used to get crinkle (swelling). Is there any correlation among degradation of NR gloves, TiO2 (pigment), Xylene and Acetic acid?

11 December 2017 1,536 1 View

How to graft polyethyleneglycol with silica nanoparticles?

I want to graft polyethyleneglycol with aminated-silica nanoparticles to get a thin film. Any help would be greatly appreciated.

10 November 2017 979 2 View

How to control viscosity of NBR latex compound with CMC thickener?

It is getting difficult to control viscosity of Nitrile rubber (NBR) latex compound which is thickening by Carboxymethyl cellulose (CMC). Is there any suggestion to keep stable with negligible...

08 September 2017 5,586 5 View

How can I avoid blisters on the styrene-butadiene rubber coating when the curing process?

I'm getting blisters problem when I'm curing my styrene-butadiene rubber coating (SBR contains high parts of styrene) at temperature > 95 celsius. Thickness of the coating is around 1.5 mm on...

08 September 2015 2,696 6 View

How can I prepare Polyvinyl alcohol coating?

How can I prepare Polyvinyl alcohol (solvent- Water) coating? Is there any cross linked agent for Polyvinyl alcohol compounding? How to dissolve Polyvinyl alcohol 100% hydrolyze in water?

02 March 2015 7,477 15 View

How does one find out Methanol concentration in a solution which is containing citric acid, methanol and water?

How does find out Methanol concentration in a solution which is containing citric acid, methanol and water? Any chemical or physical testing method to calculate each concentration?

07 August 2014 8,702 11 View

How to measure and control the viscosity of non-Newtonian fluid?

Most of the water-based rubber latexes show the behavior of non-Newtonian fluid while solvent-based rubber latexes behave as Newtonian fluid. It creates difficulties in latex glove dipping...

01 January 1970 6,765 3 View

any study on protective factors of care givers of dementia and resilience ?

need to review articles on care giving in dementia and challenges faced

12 August 2024 6,424 1 View

Adhesion strength of coating?

How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...

10 August 2024 942 3 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

How do I conformally do PR spin coating on trench structure?

I did PR spin coating on trench structure. I used AZ P4620 PR and the thickness or PR is around 11um. The substrate is Si. And my trench structure depth is 141um(negative way). Even though I...

08 August 2024 2,298 0 View

Why do i have a weak plasma and no coating during rf sputtering?

I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.

07 August 2024 4,526 4 View

Posthoc test lettering in JAMOVI?

Does anyone know of a module for the JAMOVI software that is capable of generating mean separations using the classic letters based on post hoc results (e.g., Tukey test)? If, as I believe, such...

31 July 2024 3,333 4 View

What is the reason I get 400nm nanoparticles using an extruder with 200 nm membrane for cell membrane coating?

I am trying to coat my micelles and PLGA based nanoparticles with cell membrane using an Avanti mini extruder according to literature . I use 200nm membrane but my particles end up to be 400nm And...

30 July 2024 3,294 3 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

What is the best method to detect the chemical composition of pollen ?

I have multiple small samples of grass pollen with anthers. I want to find a method to identify concentrations of proteins, lipids, and other various elements for these samples. any suggestions?

28 July 2024 5,331 1 View