Dear all,
i have to develop a Medium voltage cable pulling test procedure for providing tests at customer facilities.
I wonder if you could help me to find some suitable examples.
Description:
Pulll test is required to cable installation method without damage.
Test is to verify the following:
- mechanical integrity (no elongations)
- calculated pulling forces
- electrical parameters are not damaged during pulling operation
- the cable can be installed at required lengths.
Procedure shall include the following:
- test purpose
- test methodology
- test measurements
- test meaesurements criteria
- required measurement equipment.
Thans a lot for your help.
Fatemeh Khozaei
Dear Anatoliy Aksenenko
Basically, To perform the test, one end of a wire is fed into the gripping attachment, while the other end is secured to a fixed point. The tester then pulls the wire at a gradual pace, increasing the force until the wire breaks or the terminal is removed.
Best Regards
Dr. Fatemeh Khozaei
1 votes
1 thanks
- Badges
- Science method
- Similar topics
- Methodology
More Anatoliy Aksenenko's questions See All
Similar questions and discussions