Phytosterols (taraxasterol)
I hope you will help this article.
Thank You very much Magomed Selimov
Dear I am working on obesity and writing a review article. I want to add the topic that Why Natural products (Phytochemicals) are more beneficial than synthetic ones? I know that they have less...
02 March 2019 693 2 View
Dear Scientists, I applied the pure crude extracts (without filtration by syringe filter) on colon cancer cell lines and got some good results. When I repeated the experiment with filtration by...
10 November 2017 6,844 0 View
I have done the extraction with 90% Aqueous Ethanol of 25 gms of the sample and then filtered and then evaporated the solvent. After this, I did Lypholizations and after lyophilization, I got 0.5,...
06 July 2017 6,745 0 View
Dear scientists, I lyophilized my plant samples and after lyophilization, for some sample, I got a very good fine powder but for some samples I got a sticky solid form just like gum(Not fine...
06 July 2017 5,837 0 View
04 May 2017 3,628 3 View
hello all, Can any one suggest or send specific articles for quantitative analysis of Triterpenoids (Taraxasterol), by using C18 Column in HPLC-ELSD method ?
02 March 2017 6,830 0 View
hello every one. Can anyone send an article in which method of gradient elution for triterpenoids like taraxasterol and its acetate has been analysed by HPLC by using different gradient...
02 March 2017 9,122 3 View
Dear Scientists, I am confused now. I did extraction from plant with 90 percent ethanol at 40 degree centigrade in reflux condensor, then i evaporated the ethanol in evaporator and also in vaccum...
01 February 2017 1,921 3 View
For HPLC analysis of Phenols and Triterpenoids, what concentration of standards and samples solutions (In mg/ml or microgram /ml) for injection into HPLC should be used? I just want to know about...
01 February 2017 5,382 4 View
Can any one provide me some good articles for the determination of Triterpenoids by HPLC-ELSD methodology?
31 December 2016 284 0 View
Excessive rotation of nodes in node set ErrNodeExcessRotation-Step1
17 August 2021 0 0 View
How to calculate the RMSD values for a MD simulation using MOE?
07 August 2021 0 0 View
20 June 2021 0 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
What this unit identifies for the ion exchange capacity ca. 0.92 meq. g-1. I am a newcomer in the membrane area. I just started. I highly appreciate your help
08 May 2021 0 0 View
