Dear all, what is the standard value of electrical and ionic conductivity of Pure Sodium Bismuth titanate (NBT)?

14 July 2023 0 10K Report

What is the difference between electrical conductivity and ionic conductivity.

Badges
Science method

More Shakila Nur's questions See All

Is there a subtle distinction between the terms "substitution" and "doping"?

Dear Prof, is there a subtle distinction between the terms "substitution" and "doping" when referring to modifying ceramic dielectric materials for example Na0.5Bi0.5TiO3? Is there any difference...

08 July 2024 2,042 3 View

Problems/ Challenges regarding Dark Tourism?

Im currently writing my Thesis on Challenges/ Problems/ Particularities regarding Dark Tourism and have a little trouble finding the right literature. I have found a lot of literature for dark...

14 June 2024 7,262 2 View

When IC50 cannot be obtained according to the cell viability chart, what should be the dose selection under cell culture conditions?

When IC50 cannot be obtained according to the cell viability chart, what should be the dose selection under cell culture conditions? Would it be beneficial to go with sham control? For example,...

11 June 2024 9,109 0 View

How to calculate my FRAP Assay?

Y=0.0011x+0.1031 (Standard curve eq) Chamomile sample 20mg/mL Absorbance(y)= 1.16 x=960.82(µg/mL) Chamomile sample 10mg/mL Absorbance(y)= 0.80 x=633.55(µg/mL) Tridax sample...

01 June 2024 7,843 0 View

What are the long-term functional and aesthetic outcomes of autologous vs alloplastic materials in facial reconstructive surgery following trauma?

This question aims to explore the comparative effectiveness of using a patient's own tissue (autologous) versus synthetic materials (alloplastic) in facial reconstructive procedures, focusing on...

25 May 2024 1,790 0 View

How to determine the concentration of MXene colloidal solution?

Dear researchers, I have recently synthesised MXene by etching MAX phase source using in-situ fluoride based etchant and collected the supernatant solution obtained after the washing process. My...

22 May 2024 5,269 2 View

Do your country have Psychology Acts?

Hi/Salam; Did your country establish "Psychology Acts" for psychologists to practice? I just discovered that Malaysia still does not have the Psychology Acts for psychologists to practice, where...

13 May 2024 6,921 6 View

Dear Prof and Dr, how to calculate the recoverable energy density from P-E hysterisis loop ?

The recoverable energy density can be evaluated by the following equation: Wrec = ∫P EdP = Area CDBCJcm−3 (4) Thus, when domains are realigned by the applied electric field, the difference...

08 May 2024 4,561 0 View

RMSD plot from GROMACS output file .xtc did not start from 0ns. How to get the 0ns frame?

Dear GROMACS expert, I am currently having trouble to analyse the results from my simulations. After processing the output files using this command, gmx trjconv -s md_0_1.tpr -f md_0_1.xtc -o...

02 May 2024 6,689 7 View

How can I get involved in writing a chapter of scientific book in my research area?

Any lead will be helpful

24 April 2024 5,987 3 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 905 2 View

How to calculate conductivity using Electrochemical Impedance Spectroscopy's Nyquist plot?

Hello everyone, I am new to this characterization but watching videos on youtube I have already plotted a Nyquist plot (Z' and -Z'') and already fitted models on my material using Zsim. But now I...

29 July 2024 1,376 0 View

What is the solubility of Iron (+3) in Bismuth Oxide?

Dear all: I am modifying Bismuth Tungstate with Hematite (Fe2O3), so I would like to know about how much Iron(+3) can form a solid solution in a Bismuth Oxide matrix. Best wishes Marco

29 July 2024 2,162 1 View

Sodium azide in immunohistochemistry?

Hello everyone, A collaborator sent us his protocol in order to be able to use his immunohistochemistry kits. But one step contains PBS + 0.3% H2O2 + 0.1% sodium azide. Knowing the dangerousness...

23 July 2024 6,314 3 View

Provided that the shale conductivity termed here x increases with temperature, how could we compute it at reservoir temperature ?

one could use Waxman and Thomas (1974) work?

22 July 2024 6,637 0 View

How can we conduct DFT for solutions or mixtures ?

Can we conduct DFT studies for Ionic Liquids with Amines at various concentrations? If so, how can we proceed with these studies? Additionally, what parameters, besides IR, NMR, and HOMO-LUMO, can...

18 July 2024 319 1 View

How do I prepare a working stock solution of 14C sodium bicarbonate to get a final activity of 3uCi?

I need to make a stock solution for radioisotopic incubations of freshwater sediments to study dark primary productivity but I have some confusion as to how I calculate the concentration of 14C...

15 July 2024 5,897 0 View

Validated HPLC method for the estimation of the Amphotericin B ?

During the release test of Amphotericin B using 1% Tween 80, i observed three peaks even in the standard. The first peak consistently yielded results around 500%, while the other peaks showed...

08 July 2024 1,330 0 View

Can we detect DOC fractions through LC-OCD for a sample containing Sodium Azide?

I did some column tests in my lab where I needed to detect the DOC fractions using LC-OCD. For the abiotic columns I used sodium azide to restrict the biofilm formation. I did LC-OCD to detect the...

07 July 2024 468 0 View

How to convert magnetic conductivity from SI to lattice units?

I'm simulating a magnetohydrodynamic problem of blood flow using lattice Boltzmann method in lattice units and I need to convert the magnetic conductivity to lattice units. The physical value is...

07 July 2024 5,243 0 View