Dear researchers.

I hope this question will find you all well as I hope it reach among you those who can guide me through this small investigation.

I am trying to use ANSYS fluent to calculate the corrosion of the a pipe that is crossed by a mixture of water-vapor at around 150 degree.

The pipe is made of steel. it is just a cylinder no elbow and no complex geometries.

As I mentioned the aim is just to estimate the corrosion rate of this pipe, I found some example on youtube mainly but they are too complex on my example, the ANSYS forum did not help that much.

I would highly appreciate if anyone among would guide through the process or can share some documentation about necessary parameters to set for the software.

I would highly appreciate your feedback

More Mohammed Lamine Mekhalfia's questions See All
Similar questions and discussions