What is the difference in the data analysis process for electron scattering as compared to X-ray scattering experiment in the solution phase?

Apart from the experimental part (where an additional problem of radiolysis (ion generation) in presence of electron beam is there) what other problems (like multiple scattering) might one face in...

10 November 2019 7,654 1 View

Using which experimental technique do I find out the molecular packing in an organic nanoparticle ?

06 July 2017 5,205 0 View

How can I understand the basics of 2-D electronic spectroscopy?

Especially how do I interpret 2-D electronic spectra? What do the absorption and emission axes signify?

04 May 2017 3,049 2 View

How do you explain diabatic and adiabatic potential energy surface?

Quantum mechanical description will help.

11 December 2016 2,385 0 View

Can you suggest a solvent for dipyrene?

It is okay even if I have to warm up the solvent a bit.

09 October 2016 4,449 3 View

Are there any interesting paper or scientific studies on compound eyes of Insects?

Also if there are any interesting study on photonic crystals please provide the links.

08 September 2016 4,597 0 View

For the XRD spectrum of graphtic Carbon nitride, why the peak at 27.4 degree is much more intense than that of at 13.1 degree?

What does this relative intensity correspond to?

04 May 2016 3,790 6 View

What are some easy ways of preparing methyl formate in the laboratory?

Procedure should involve easily available chemicals in the lab.

02 March 2016 7,098 1 View

How to prepare formic acid from formaldehyde or formamide in the laboratory?

Please provide me with an easy procedure.

02 March 2016 8,744 0 View

What are some efficient bottom-up approaches for synthesizing carbon nitride quantum dots?

I am trying to make CN QDs with size of about 60nm.

02 March 2016 9,357 1 View

How the parameters (such as Mw, Chemical bonds, polymer bland and so on) affect the mechanic property of polymer (such as storage, loss modulus) ?

Anyone can recommend any books on such topics? Thanks in advance.

02 March 2021 8,457 2 View

Why Austenite grains in steel show much more twinning than ferrite grains?

It is oftentimes said to be a distinctive metallographic trait that differentiates a fully austenitic and a fully felly ferritic steel without etching that might distinguish between two. Why...

02 March 2021 728 2 View

How to define and get results (stresses) for certain points of a model in abaqus, using python? When the size of the model changes?

I want to do a parameter study of a aixsymmetric cylinder in Abaqus. I want to create several jobs where I get the stresses for 3 different points in my model. These points are defined. I wrote a...

01 March 2021 10,078 1 View

LOAD DISPLACEMENT CURVES Stiffness increasing in ANSYS non linear analysis. HOW CAN I CORRECT IT?

Hi. I am doing non linear FE analysis using a new material beam under flexural 2 point loading using ANSYS. I have defined a bilinear material model. The solution has converged. In results I am...

01 March 2021 9,911 3 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

How to remove the residual PDMS on the silicon mold?

Incompletely cross-linked pdms are difficult to remove.

01 March 2021 798 3 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

How relevant is Mini slump cone?

for all the rheology researchers, my question is, how relevant is a mini slump cone (smaller than a standard 50 cent rheometer). currently based on testing, the thickness of slumped material is...

26 February 2021 3,668 1 View

Stress/strain tensors decomposition ???

25 February 2021 6,760 1 View

Modeling viscosity using model of Chung?

Hello, As part of simulation of gases mixture and water, I need to calculate viscosity of the fluid components and I am using relationships proposed by Chung et al. (1988). The irony is while I...

25 February 2021 8,053 5 View