Can we use deep eutectic solvent as extraction solvent in LCMS?

Asmaa Kamal El-Deen @Asmaa_Kamal_El-Deen

12 December 2018 0 7K Report

Why we can not use deep eutectic solvent as extraction solvent in LC-MS ?! Is this related to the high viscosity of most of them ? or their low volatility ?!!

Badges
Science topic

Similar topics
Chemistry
Chemicals
Solvents

More Asmaa Kamal El-Deen's questions See All

How to dissolve photoinitiators TPO and Irgacure 2959 for cytotoxicity assay?

Hi. I am working on a project to study the cytotoxicity effects of various photoinitiators on different cell lines. However, I am not sure how I can dissolve Irgacure 2959 and TPO since using...

26 October 2023 8,279 2 View

Can we use celestite as a substitute for barite to improve bentonite as drilling mud for oil wells?

Iraq has no barite, but celestite can be found on some sites, need to use this celestite as a partial or total substitute for barite in thinking the drilling mud in the oil industry in Iraq

15 April 2023 565 0 View

Is precipitated calcium carbonate is nano calcium carbonate?

we have a process to precipitate CaCO3 we need to control product particle size

11 March 2023 4,920 7 View

My research team need secondary experimental data on the behaviour of tall buildings under wind loads; unprocessed data. Can someone please help?

Hi All I am participating in research on numerical simulation of tall buildings' behaviour under different levels of wind speeds (in terms of magnitude). My team need secondary experimental data...

14 September 2022 8,040 2 View

RPMI 1640 or RPMI 1640 with HEPES for SH-SY5Y neuroblastoma cells?

I am working on neuroblastoma cells and just wanted to optimize cell culture conditions. I just need to know whether RPMI 1640 with HEPES can be used or not. Thanks in advance.

17 November 2020 263 0 View

How to transfer the particle suspended in aqueous medium into a non-aqueous (organic) medium?

I have ctab capped gold nanoparticle dispersed in water. I want to transfer the gold nanoparticle into a non-aqueous or organic medium. Can anyone please suggest me how to successfully transfer...

14 October 2020 2,904 4 View

LC Q-TOF binary pump could not switched on ?

Dear all We tried to switch on the LC system of our Agilent Q-TOF, however upon switching on the binary pump, it takes a minute and then an error appears. When we tried to check the pump by...

17 June 2020 8,730 0 View

How can I produce vanadium inhibitor for both HFO and crude oil?

Power plants use HFO and crude oil in the combustion chamber, the damages caused by vanadium pentoxide is very harmful to the power plant so I have to add inhibitor to the fuel

08 June 2020 7,138 0 View

What should I use to overcome the higher segregation index element in metallurgical silicon?

I need to refine metallurgical silicon to poly crystalline silicon but the source contain 60 ppmw P and 40 ppmw B

11 May 2020 7,843 1 View

What carbon materials should I use to lower P & B in metallurgical silicon?

I have to produce MG-Si with lower P & B content, I already use charcoal and coke but the P&B content is very high

11 May 2020 4,295 0 View

Is there a problem with my RNA pellet?

Hello, I am currently having problems with RNA extraction. I am using mouse liver (C57BL6J), and I have extracted RNA from mouse liver before. Before this experiment, my final RNA pellets were...

11 August 2024 7,082 3 View

Ethylene glycol is newtonian or non newtonian fluid?

Some sources say it is treated as Newtonian as ethylene glycol has a higher viscosity than water, which affects the flow characteristics in simulations. But some also say it is non-Newtonian.

09 August 2024 2,111 2 View

RNA Extraction Using Hot Borate Method No Longer Working?

I've been performing RNA extraction on cotton petiole tissue for a few months now using the method described in the following paper, a derivative of the typical hot borate method...

08 August 2024 9,882 2 View

What is the solvent for 8YSZ nano material?

I need to do some experiment with it in liquid form.

07 August 2024 613 3 View

How can major oxides determined by ICP-MS/ES be normalized to 100% volatile free? How does this connect with LOI?

I am analyzing cherts from different sources found within one specific geologic formation using ICP-MS/ES. My committee was asking this question about my analysis. I was not sure how to answer this

05 August 2024 7,902 3 View

Low-yield gel extraction problem?

I am having an issue with my gel image where my PCR product is not appearing very bright on the gel. When I perform gel extraction, the A260/280 purity value is very low. I used the Qiagen gel...

05 August 2024 9,798 3 View

Usage of internal standards in LC-MS/MS analysis?

Have you ever seen a LC-MS/MS method uses both internal standards and external standards (in matrix matching purpose) but the concentrations of internal standards are outside the calibration curve...

05 August 2024 3,084 6 View

Do you have good tips for seaweed tissue preservation in the field for post RNA extraction?

I will be with my students collecting seaweed samples in a marine farm and later we will process this tissue for RNA isolation and further sequencing. Does anyone have tips on how to collect the...

04 August 2024 501 2 View

The question is how to use Wavenet transform?

HOW CAN I WRITE A CODE TO USE THE WAVENET TRANSFORM AS A FEATURE EXTRACTION METHOD INSTEAD OF DWT IN MATLAB?

03 August 2024 7,829 0 View

Which solvent is better to dissolve with secondary metabolites extracted from fungi?

I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...

03 August 2024 4,725 2 View