Can someone provides me some sources/materials/pdfs to understand the RHEED oscilation?

More Sougata Koner's questions See All

What is the cause of the requirement of O2, N2 etc. gases in PLD thin film deposition process?

PLD thin film deposition technique is used to deposits the layers of ceramic oxides by the laser ablation process. There is some use of O2, N2 gas etc. cylinders in this deposition technique. What...

11 December 2023 3,210 2 View

What is the benefits of fabrication of dot like electrodes in the thin film heterostructure?

Many reported thin film heterostructures shows dot like electrode fabricated on the ferroelectric phase to extract voltages or current density from the structure. But, it also can be fabricated a...

20 November 2023 7,126 0 View

Why magnetostrictive alloys have higher magnetostriction compared to metal?

Magnetostriction of metal alloys like Terfenol-D, Metglas have higher magnetostriction compared to Ni, Co and Fe.

20 September 2023 6,007 0 View

Why we are interested in particular level of elements in XPS?

Whenever we irradiated a sample with x-ray(with energy Kev), there is a probability of emission of photoelectron from different core levels. But generally people reports for the XPS peaks for a...

08 September 2023 7,922 4 View

What is reason of higher eddy current loss of magnetostrictive metal alloys?

Eddy current loss in magnetostrictive alloys.

09 July 2023 10,014 0 View

How to determine phase of an unknown compound by XRD technique?

Phase of unknown compound by XRD method

14 June 2023 8,395 26 View

Can I use the square root transform data of a weed population to calculate weed control efficiency?

Weed control efficiency calculation

06 June 2023 5,496 3 View

What are the fabrication methods to fabricate thin film multiferroic heterostructures?

Thin film heterostructures

28 May 2023 9,548 2 View

What are benefits of epitaxially grown thin film rather than polycrystalline thin film? What is the benefits of thin film grown on substrate as phase?

Epitaxial thin film, thin film substrate

21 May 2023 8,976 6 View

How to reduce the clamping effect of thin film substrate?

Clamping effect reduction of thin film

16 May 2023 300 9 View

Using OBD technique i am trying to measure laser induced shockwaves velocity i found that at start velocity increases and then decay?

i am unable to interpret why its increases in start as shown in figure

11 August 2024 2,179 1 View

Hello researchers Is this a random laser or just fluorescence?

I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.

09 August 2024 9,894 2 View

What procedure should I follow for current controlled PPy film electrochemical deposition on ITO?

For example, I perform passivation process before electropolymerization of Py for adhesion to titanium surface. Is a similar or different procedure required for ITO? If necessary, I would be glad...

06 August 2024 3,176 0 View

Could dyes amplify the spectrum of light to a specific wavelength?

I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...

05 August 2024 3,290 1 View

Best mask design for metal deposition aiming build a Perovskite solar cell device?

What types of mask designs for metal deposition, to be used in a PVD system, are best suited for perovskite-based solar cells?

31 July 2024 4,835 3 View

How should operational parameters be selected when developing a pore-free laser welding technology?

There are three operating parameters - the laser power, the diameter of the focus spot and the scanning speed. It is necessary to obtain a seam of a given depth without pores. What parameter...

27 July 2024 7,168 2 View

Can we fit a gaussian Fit on a LIBS Peak ?

Though much literature suggests fitting a Voigt profile on a LIBS peak, is it also possible to fit a Gaussian profile on the LIBS peak? I have 204 spectra files, and I am building a pipeline for...

23 July 2024 6,127 1 View

How to download free version of BiofilmQ ?

I would like to use biofilmQ to analyse confocal laser image, how can do?

16 July 2024 7,628 2 View

What should be consider when do CVD?

I'm trying to create a new substance. Are there any important considerations when fabricating with CVD? For example, lattice constant If you have any such considerations, please let me know.

15 July 2024 9,359 0 View

How to install Quantum Espresso with Intel compiler ?

Hello ! I would like to do band structure calculations of perovsikites materials with quantum espresso. For this I installed the Intel Fortran compiler. This is what I get when I run the...

08 July 2024 1,207 0 View