I have been trying to run DIYABC on my microsat data. All looks fine according to sample input files, and the program reads my file fine. However, I cannot get beyond setting my historical models. I continue to get an error message that states that I must indicate when samples are taken. No where in the manual or online have I found out how to do this. If I use the provided sample dataset, I get the same errors. I'm at a loss. Can anyone help?
Hi Jessica, Maybe you can solve the problem if you state the timing differences in each scenario. You need to select each scenario, go to the bottom and you will see you can select if time ta is < or > or = than tb, etc. Do that for all the scenarios. hope that helps.
Hi Jessica, I think what you're looking for it right at the bottom of page 8 of the manual. It should like this for example "0 sample 1" (meaning at time present I sampled population 1)
Copied from the manual:
population sample : time sample pop - time is the time (always counted in number of generations) at which the sample was taken and pop is the population number from which is taken the sample.
- Badges
- Science topic
- Similar topics
- Computer Science and Engineering
- Bioinformatics
- Bioinformatic Tools