As for performing the analysis in ABAQUS, since you mentioned that you are a beginner, it's important to ensure that the analysis setup is correct. This involves defining the appropriate element types, material properties, boundary conditions, and loading conditions for your cyclic analysis. Let me explain, after running the analysis, you need to access the results in the Visualization module of ABAQUS. Here, you can create an XY data plot to display the response quantity (e.g., force) versus the control quantity (e.g., displacement) to visualize the hysteresis behavior. In the Visualization module, go to "XY Data" and create a new XY data plot. Select the appropriate history output data for the response and control quantities from your analysis results. Once the XY data plot is created, you can plot the hysteresis behavior by plotting the response quantity (e.g., force) on the Y-axis and the control quantity (e.g., displacement) on the X-axis.

I checked your model, it have multiple mistakes in the definition of boundary conditions and outputs along with the meshing. Revise the Step, Load and Meshing to get accurate results.

Engr. Tufail Thankyou for your response. Can you please specify where are the mistakes and what are the best ways to get results and where and what type of improvement needed Thanks]