How to analyze a particular region of my simulation box in GROMACS?

Hi, I am using GROMACS 5.1.4 to simulate water in contact with a surface. I am only interested to calculate some properties of water near the surface. Let's say at a distance of x nm from the...

03 March 2021 9,989 2 View

Can the Dunn's test be used as an appropriate post-hoc for the G-test?

Research Question: Are red grouse (Lagopus lagopus scotica) a statistically significant proportion of raptor (bird of prey) diets? I am planning on using a series of G-tests (determining whether...

23 February 2021 5,827 3 View

How to indicate the degree of litter decomposed by microbes?

Any technique could detect the degree of litter decomposed by microbes? Or any indexes could do this job? I want to split the contribution of microbes during decomposition, so any suggestions...

23 February 2021 1,362 5 View

How to estimate 2SLS with different instruments for different endogenous variables?

To be specific, I want to conduct an IV regression in stata with the following three equations. EQ1: Y1 ~Y2 Y3 X EQ2: Y2 ~ Z1 EQ3: Y3 ~ Z2 Both Y2 and Y3 are endogenous. However, Z1 and Z2 are...

23 February 2021 6,266 3 View

What low-cut filter (high Pass frequency) to be used for response spectrum (Tripartite plots) ?

What low-cut filter (high Pass frequency) to be used for the response spectrum (Tripartite plots)? I am currently working on differentiating between hard/soft site responses in Indo-Gangetic...

21 February 2021 9,273 2 View

Where can the fault diagnosis data set of lithium battery be found?

Most of the data sets on the network only contain good information about the voltage and internal resistance of lithium batteries. The data of faulty battery is missing. Who can help me, I will be...

21 February 2021 8,659 1 View

How to define the sink temperature and film coefficient?

Hi, everyone. I am considering the heat conviction during compacting simulation by Abaqus. I was wondering that how to define the sink temperature and film coefficient? Is there any references...

21 February 2021 6,197 1 View

How to discriminate between Sentinel-2 Level-2A Product Discriminators?

According to the Sentinel-2 user guide here (https://sentinel.esa.int/web/sentinel/user-guides/sentinel-2-msi/naming-convention), the compact naming convention is arranged as...

21 February 2021 5,919 9 View

Are ZnS nanoparticles moisture sensitive?

Hello Everyone, I tried to form ZnS nanoparticles using the hot injection method and was able to form the same (confirmed by XRD). When I centrifuged, after the reaction I got a kind of white...

17 February 2021 1,709 3 View

Can anyone suggest a software for running a plant tissue culture lab?

A software which can help to design the experiment, store data, update new data, set subculture reminders, barcoding etc. Like Invitrosoft.

17 February 2021 3,015 5 View

What could be possible reason of higher Drug Concentration of Liposomal formulation stability samples over time?

Hello Everyone! I have prepared liposomal formulation using Rotary Evaporator method followed by dialyzed the liposomal Suspension in Phosphate buffer to remove the un-encapsulated drug. After...

25 January 2021 7,752 4 View

Is there a way to prevent agglomeration of chitosan when i add a chitosan solution dropwise to a bilosomes suspension for the purpose of coating?

I am doing research on the incorporation of bile salts into liposomes and coating the exterior surface with chitosan for enhanced stability in the GIT. Eveything goes well up until the point where...

14 December 2020 4,894 3 View

What basic protocol can you recommend for making liposomes with a highly water insoluble drug?

I am new to liposome making. My drug (carbamazepine, mol wt. 236) is highly insoluble in the water. I tried to load it in bilayer using a basic protocol. After lipids(DMPC, DMPG, Cholesterol)...

23 November 2020 4,886 3 View

Did anyone used microflow imaging to measure the size distribution of Multivesicular liposome which are charcterized with size (>3um)??

I have prepared Multivesicular liposomes using the following procedures: Multivesicular liposome formulations for the sustained deliv... Multivesicular liposome (MVL) sustained delivery of a...

18 November 2020 3,189 2 View

How to dye DOPC liposome with Dio c18 fluorescent dye?

13 November 2020 9,244 3 View

What pH buffer solution best replicates physiological conditions?

I am studying the interaction between protein (HSA) and liposomes (made with DMPC) and I would like to study under physiological pH for application in studying protein interaction with DDS. I have...

10 November 2020 3,594 3 View

I warp BL21 cell extract into a POPC liposome, why does it bust in a very short time?

I am trying wrapping Ecoli BL21 cell extract into POPC liposomes but they burst in a very short time. However, when I wrap LB in the liposomes, they remain stable for a long time.(Liposomes are in...

21 October 2020 3,206 3 View

Why we can't apply energy or forcefully dissolve lipids when preparing liposomes by thin-film rehydration?

I have read that we can't apply energy or forcefully dissolve lipids when preparing liposomes by thin-film rehydration? I can't remember why or find the source of information, any help?

11 October 2020 3,950 3 View

Will Endonuclease-1 in my Plasmid Miniprep Effect my Transfection Efficiency?

Hello, I have a lentiviral vector which I hope to package into virus by cotransfection with an envelope plasmid into a packaging cell line (293FT). My lentiviral vector is in stbl3 E. coli,...

05 October 2020 9,629 4 View

Difference between polymeric nanoparticles and Liposomes?

What is the difference between PLGA PEG nanoparticles and Liposomes? any recommended papers or reviews that explain the pros and cons of each formulation ??

06 September 2020 6,341 3 View