Can anyone tell me, how can I precipitate the Fe3O4 nanoparticles by using cholroform? Should I degas the chloroform before use?

More Ajinkya Nene's questions See All

For carboxylation of graphene got 2 peaks at two theta 26 and 54. Is this proper data ? anyone can tell me about XRD peaks of carboxylated graphene?

carboxylated graphene

08 September 2015 949 0 View

Can I publish my work in low or high impact factor journal related to synthesis of Fe3O4 nanoparticles , I have TEM,XRD and XPS results?

nanoparticles

04 May 2015 7,694 1 View

How much impact factor can i get if i have done synthesis of nanoparticles by a new method?

nanoparticles

04 May 2015 2,527 1 View

Hello researchers Is this a random laser or just fluorescence?

I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.

09 August 2024 9,894 2 View

How to prepare the nanoparticle treated fungal sample for Environmental SEM analysis?

A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.

07 August 2024 5,307 1 View

Binder for ZnO nanoparticles in graphite paste electrode?

I have been using paraffin, but the deposited ZnO still detach from electrode. What is the best binder to modify graphite paste electrode with ZnO nanoparticles?

03 August 2024 4,624 3 View

Can i quantify a nanoparticle encapsulated in cell culture medium by hplc?

Hello, if you made a transwell assay where you incubate the cells with a nanoparticle-encapsulated drug and considering that in the oposite compartment you'll have both the free and encapsulte...

03 August 2024 2,730 1 View

Mossbauer spectroscopy Co0.6Mn0.4Fe2O4 MNPs?

Following curve related to Co0.6Mn0.4Fe2O4 Magnetic nanoparticles with extra phase a-Fe2O3. I will appreciate to help me to interpretation this spectroscopy, especially the blue line.

31 July 2024 9,140 2 View

How to remove/ replace trifluoroacetate countertop after deprotection?

After deprotection of the tert-butyl ester to generate the carboxylic acid in chloroform with TFA, my compound‘s pyridine moiety forms a TFacetate ammonium salt (small molecule drug, not a...

29 July 2024 9,753 3 View

Addition of EDTA during the synthesis of copper nanoparticles to prevent it from being oxidized?

I've attempted to use this method to synthesize copper nanoparticles. Copper nanoparticles can be synthesised using a variety of precursor materials. CuSO4, distilled water, NaOH, and EDTA are...

28 July 2024 8,027 3 View

Optimal siRNA Volume for Complexation with Liposomes in a 2.5 mL Solution with 10 mg/mL Lipid Concentration?

How much volume of siRNA can I add to 2.5 mL of liposomes with a total lipid concentration of 10 mg/mL?

27 July 2024 6,920 1 View

What are the modern methods for detecting nanoparticles?

Some of the techniques I am familiar with are standard. I would like to know which of the two methods under study is preferable, as well as the cost and list of particles and devices needed in...

22 July 2024 1,921 3 View

Why methanol and sulphuric acid used in the analysis of polyhydroxyalkanoates (PHA) by GC-MS?

Why methanol and sulphuric acid, used in the analysis of polyhydroxyalkanoates (PHA) methyl esters by GC-MS? Additionally, why do we typically use non-polar solvents in GC-MS?

22 July 2024 1,210 2 View

Ajinkya Nene

John George Hardy....actually I am using chloroform after synthesis to precipitate the nanoparticles...so, you mean I should not worry about its degassing?

Omkar S. Kushwaha

If you place magnet under your chloroform solution, Fe3O4 nanoparticles being magnetic will settle down.

Alsayed A M Elsherbini

I do know why you use chloroform. any way you can use the magnet or evaporation method at ambient to isolate the magnetic nanoparticles

Alsayed A M Elsherbini ...so there is no need to use chloroform? can i filter the reaction mixture after cooling it down?