Can anyone recommend a good commercial unit for DMSO solvent distillation and recycling?

05 May 2016 1 3K Report

Two to five gallon batch processing is sufficient. A refrigerated condenser is preferred so that cooling water is not required.

Klara Szita

Dear Paul,

It is a good question. I try apply to use 1 m3 solvent waste with 20 % DMSO content as functional unit in LCA and/or 1 kg recovered DMSO from the waste solvent. It is a dilemma jet what is the best during a distillation recovery process .

Badges
Science topic

Does matter flow through ecosystems and energy is recycled and how does the flow of matter and energy compare in the living world?

03 August 2024 607 2 View

Which solvent is better to dissolve with secondary metabolites extracted from fungi?

I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...

03 August 2024 4,725 2 View

I need to dissolve stigmasterol for an animal experiment, it hasn't dissolved in either DMSO or vegetable oil. Can anyone recommend the best solvent?

Hello everyone, I need to dissolve stigmasterol for an animal experiment, but it hasn't dissolved in either DMSO or vegetable oil. Can anyone recommend the best solvent for stigmasterol?

01 August 2024 7,504 2 View

Water Consumption in Plastic Recycling: Is it Higher Than for Virgin Plastics?

Hello, dear colleagues, I would like your help in finding a reference that provides an average water savings due to plastic recycling compared to the consumption of virgin materials, preferably...

29 July 2024 4,630 0 View

Which filtration method to go for run off water from dirty solar panels to be used again?

We are working on a robot that cleans solar panels using fresh water supply and a rotating brush. We are trying to conserve as much water at possible by recycling the dirty water that is collected...

28 July 2024 5,778 2 View

How is surfactant addition calculated?

I want to make 100 ml of MWCNT/distilled water mixture at a volume fraction of % 0.1. MWCNT density is 2100 kg/m3. I will add gum arabic as surfactant. If I add surfactant at a 1:1 ratio, will the...

19 July 2024 8,494 0 View

What is the suitable solvent of MIL-100 for chemotherapy?

I synthesised a nanocarrier by conjugation MOF (MIL-100) with folic acid for use in chemotherapy but the samples didn't dissolve completely in aqueous solution or DMSO. Instead, they only...

19 July 2024 8,522 0 View

Kraft lignin and MMA(Methyl meth acrylate) free radical polymerization for synthesis of thermoplastics?

I am conducting free radical polymerization using Kraft lignin and MMA, with DMSO serving as the solvent and there is also an initiator. Following the reaction, I obtain a solution, but I am...

15 July 2024 9,827 1 View

Regarding solubility of Dorsomorphin in DMSO ?

I'm using Dorsomorphin (C24H25N5O) as one component in dual SMAD inhibition of pluripotent stem cells to differentiate into neurons alongwith SB431542. Now as to solubilizing 10mg SB in DMSO for...

11 July 2024 4,832 0 View

How i can calculate mathematically COD concentration if i add 1gr from glucose to 1 L distilled water ?

how i can calculate mathematically COD concentration if i add 1gr from glucose to 1 L distilled water

08 July 2024 9,104 2 View