Hi Ashref !

First of all i want to know that which package you going to use for this problem ?

I worked on a reinforced concrete problem in ansys apdl when i was doing FEM course but now its quite hard for me to predict your problem so either you write some details of your problem or i think i ill send you that files so you can learn it from them if you gonna use apdl .

regards

S Shukla

Atena, Abaqus or Ansys can be used in your case.ReConAn FEA is specialized in doing exactly what you are looking for.It is not available though as a complete package given that it is an in house research software that uses Femap as a graphical interface.You can download the manual from my publications so as to have a general idea about the capabilities of the software or visit my website.

Regards

Thank @Shrish Shukla,

I am try to model T- joint with abaqus, but am not sure about the way am using.

hope if you have any reinforced concrete abaqus model I'll be grateful.

Regards

@George Marko,

I visit your website, it seem to be a good software but at this moment I am using abaqus, I have used it before but not in reinforced concrete.

Tanks

Dear Ashref,

I would like to refer you to following paper. Any question, you definitely can contact me and I hope giving you my best help.

Danesh, F., Esmaeeli, E., and Alam, M. F. (2008). "Shear Strengthening of 3D RC Beam-Column Connection Using GFRP: FEM Study." Asian Journal of Applied Sciences, 1(3), 217-227.

http://docsdrive.com/pdfs/knowledgia/ajaps/2008/217-227.pdf

hi, it is important that you want model in macroscopic or microscopic simulation of concrete with reinforce. so, in a macroscopic simulate you should use composite (layered) element on the software and for microscopic simulate, should use plane element for concrete and bar element for reinforced in according your data. and repeat it to make an model.

I think you can read several my papers to understand about composite material modelling.

Hi, i am working on RC shear wall. I have modeled RC shear wall.

I am using c3d8 element for concrete and T3D2 for reinforcement.if u want more help then tell me i will send video of procedure.

Dear Esmaeel

Thank you very much for the paper I try the same steps, but i didn't get a logic result.

I don't know where is my mistake if you don't mind I'll send you the file.

Regards,

Sure, Please send it to my email address (files with extensions of CAE and JNL should be sent) : [email protected]

Esmaeel, I already send the JNL to your email.

Thanks

OK, in next few days I will be back to you.

Renish Dhaduk,

Thanks for replaying, I would like to see the video.

Thanks,

can anyone help me out.......with tutorial pdf video to model RCC and shear wall....in abaqus . my email address is [email protected]

Hi, could you please anyone, send me a ABAQUS video tutorial or pdf file how to model reinforced concrete column strengthend with FRP. Your help will be greatly appreciated. Thanks

HI,

i am trying to modely cyclic behavior of composite shear wall in ABAQUS - if anyone has any knowledge on this topic can you please share. I haven't found any responses regarding this question, but maybe pdf or video tutorial of RCC and shear wall will be helpful. So if anyone can share it i will be very grateful. my e-mail: [email protected]

thanks, ivan

can any one send to me how I can model concrete filled tube in abaqus

my email is: [email protected]

please send me the same video about reinforced concrete structure modelling in abaqus.. it is urgent..  my email id is [email protected]

Was anyone able to find a video demonstrating how to model a reinforced circular column  ?