Hello,

I have written a UMAT subroutine but when I run the code it runs and completes successfully. I am using C3D8 elements. The subroutine is working fine, as the job completes successfully. However, when I try to see the results from the ODB file I get the following message error:

“The selected Primary Variable is not available in the current frame for any elements in the current display group.”

Could this be because there is something wrong in my subroutine? I will appreciate your input. Please see the UMAT file attached.

I have tried to select the stress, strain and magnitude and all not available.

I have tried to run the input file with an in-built material model (say, linear elastic) and I did not encounter the same issue. Everything was OK.

More Mohammad Reza Bayat's questions See All
Similar questions and discussions