Hello. Can anyone help me with a link to download or buy UVWin 5 (or 6) Software for UV-Visible Spectrophotometers.
Thank you!
I am trying to run an SDS-PAGE after his-tag purification of a sample. The protein of interest is an oligomerising membrane protein with an YFP tag attached. When the fractions of the sample from...
07 September 2020 3,277 6 View
Our team is looking for viral RNA in the environment. We took swabs off of doorknobs using cotton dipped in water and then submerging that swab in viral transport media. We also wiped 1 surface...
08 June 2020 6,532 3 View
During metabarcoding of endophytic fungi, many seem to use ITS primer pairs that are not (fully) selective for fungi. We experienced that such primers also amplify the ITS region of an in vitro...
09 March 2020 3,303 2 View
My feeling is based on the following idea: Expected behaviour of financial data could have ordering properties. For example one may expect the increase in price of some stock in a given time...
21 June 2015 5,343 3 View
15 April 2015 3,422 4 View
Is it necessarily to reach the normal 0.9-1, 1mmol/L or higher, 3-5mmol/L? Does the actual lactate level of an athlete influence the actual physiological state?
03 June 2013 217 2 View
Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !
02 March 2021 5,785 3 View
I measure the wavelength of material in a spectrophotometer and it peaks at 275 and its absorbance is 100. I mix it with an adsorbent and it adsorbs the first material, but when I measure the...
16 February 2021 7,515 5 View
I'd like to know if anyone can provide me with a protocol for traditional catalase enzymatic assay in a 96 well microplate, for cell line and/or C.elegans spectrophotometric measurements. Thanks!
11 February 2021 7,273 3 View
I know colorimetry has been the standard way by way of measuring the concentration of a particular compound (solute) in a colored solution (solvent or measure quantities of a particular compound...
08 February 2021 2,673 1 View
Hi there, I would like to determine the unknown concentration of human insulin in my sample during crystallisation (the concentration range is roughly 0.5 -2 mg/ml, whereas the initial...
06 February 2021 9,370 7 View
Hi guys. I make RNA by in vitro transcription and do cell transfection afterwards. I analyze RNA using Nanodrop and Bioanalyzer. But I found the concentration of RNA measured by these two machines...
05 February 2021 292 3 View
I have prepared gold nanoparticles using the citrate reduction method in the lab. I need to characterize them using UV-Vis and DLS, by how much should I dilute my sample for using it in the...
26 January 2021 530 5 View
I want to calculate the concentration of DNA in an unknown sample. But it's buffer has a high concentration and our nanodrop don't accept that as a blank of dsDNA. Thus I dilute the buffer with...
23 January 2021 9,440 2 View
I am working on PVA-GMA hydrogel that is a really strong polymeric structure like rubber. Because I am in the middle of analysis, it is difficult to dissolve the gel using a common solvent. I...
20 January 2021 3,501 2 View
I am trying to assess chlorophyll-a content from coral tissue using spectrophotometry (with SPECTROstar Nano, BMG). However, I always seem to obtain some negative values in my optical density raw...
20 January 2021 1,542 4 View