How can I access the international articles related to Crop Monitoring?

I am planning build my career in agricultural development using remote sensing. Now I started surfing through articles for gaining knowledge. Could anyone can suggest me some articles?

25 August 2020 2,345 7 View

Anyone suggest me a topic for my research regarding organizational stress?

I am doing my M.Sc Psychology (HRDM). I have been asked to choose a research topic regarding Industrial psychology. Thanks in Advance!

13 March 2020 5,288 13 View

Is the Reference Intensity Ratio of Martensite(7.98) and that of Austenite (10.81), standardized against corundum, constant?

I came across the RIR value of Martensite in a paper, which is 7.98. Similarly for Austenite, which is 10.81. I want to quantify Retained Austenite in my heat treated samples. I am using Reference...

26 February 2020 9,401 2 View

Why vedic mathematics based algorithms are not seen in reputed journals of algorithms, Hardware Architectures?

Why vedic mathematics based algorithms for division, multiplication etc. are not seen in reputed journals of Algorithms, Hardware architectures.

01 May 2019 9,805 2 View

If serum zinc level decreases with zinc supplimentation in diabetic patients, what is the significance? plz help?

I have done a serum zinc bioavailability study in Diabetic patients. Zinc bio acive nanoparticles (Yashada bhasma ) was administered orally. Serum zinc was measured before the beginning of drug...

09 November 2017 3,336 2 View

What is the significance of a negetive charged Zeta potential of a nanoparticle ?

12 September 2017 3,100 2 View

Can anyone suggest me references for Carreau-Yasuda model for validation of fully developed Non-Newtonian flow inside a 3D Pipe ?

19 December 2016 7,472 2 View

Why amorphous Al hump is not showed in XRD while amorphous region observed in HRTEM?

I have a HR-TEM image of pure Aluminum which wass ball milled for prolonged hours. HR TEM images indicate that there are significant amount of amorphous region coexisted with crystalline Aluminum....

20 October 2016 3,493 3 View

Can anybody suggest protocol for isolation of RNA from formalin fixed bone samples?

I have animal bones fixed in formalin , is it possible to do gene expression analysis - mRNA expression studies using these samples. ..

03 February 2016 7,891 2 View

How can I seed cells onto a collagen sheet?

I m using collagen impregnated with plant extracts for my studies. I want to check biocompatibility of the material using MTT assay. Can anyone suggest me a detailed protocol for the same?

07 February 2015 4,143 5 View

What is your perception on using visual analysis or quantitative approaches to evaluate data from single-case research designs (n of 1 trials)?

Results of single-case research designs (i.e., n-of-1 trials) are often evaluated by visually inspecting the time-series graph and computing quantitative indices. A question our research team is...

03 March 2021 687 1 View

How do I increase the yield of my PCR product?

Hello, We would like to increase the yield of our PCR product. We are running a series of PCR reactions that is targeting ~1.1kb sequence. We begin each reaction with ~400pg of template DNA...

02 March 2021 4,029 3 View

How to quantitative analize the data of TNBS assay for gelatin?

Estemeed colleagues, I found some issues regarding the quantification of the data for TNBS assay. There are different protocols on how to perform that but it is clear to me the "fil rouge" that...

02 March 2021 2,616 1 View

Research on Supply Chain Management in Indian context?

Hi, I am planning to apply for the PhD degree in the Supply Chain Mgt. with specific area of "Cold Storage warehouses" during Pandemics and wars. Where lock downs and shut downs are frequent....

02 March 2021 285 2 View

PACYC PCR not working after several attempts. Would anyone have any suggestions?

So, I have been trying to run a pACYC PCR which will be used later on for a Gibson Assembly. However the PCR is not working. I have already tried gradient PCR and changing extension time; however...

02 March 2021 1,146 2 View

How to address this issue in the analysis of Real-Time PCR results?

To dear Researchers, I was analyzing a series of concentration for estimation of Real-Time PCR efficiency. The concentration was 1:10. I used MS-excel to evaluate Slope. The result of slope was -8...

01 March 2021 8,683 4 View

How to accurately quantify chitin?

Hi all, I have been working on the quantification of chitin in insect samples and feed for a while but I can notice that the quantification methods (e.g. exposure to HCl, NaOH, and weighing sample...

01 March 2021 1,843 2 View

Why is the efficiency of viral mRNA electroporation in PBMC low?

Hello, I have been struggling with the electroporation of PBMC with HIV-I mRNA. Although the quality of the RNA generated is good, and the handling of the cells in meticulous, the frequency of...

27 February 2021 9,233 3 View

Runs of nucleotides in Sanger sequencing?

I performed site directed mutagenesis, transformation, and then I sent out plasmids for Sanger sequencing and found out that there is extension of DNA just before the stop codon. I am not sure...

27 February 2021 547 3 View

Can thermal cycler machines be problematic during PCR?

Hi, my question is about the heating of thermal cycler machines and I hope some of you had experienced a similar thing previously. There are two thermal cycler machines in the lab(BioRad) and for...

26 February 2021 4,777 4 View